Overview
The Eaton 19659-010 is an E-Locker for GM 10 Bolt axles measuring 8.5 inches and 8.6 inches, with 30 splines. Pressing a push button moves the locker from open to locked, and the unit needs only 12 volt power.
The unit can be fitted in front or rear axle positions. A locked axle sends drive torque to both wheels together, which helps when one wheel loses grip on loose or slick ground.
Key features
- Electronic push button selection between open and locked
- 12 volt power, with no air lines to leak
- No cables to snag on rocks or brush
- GM 10 Bolt axle types at 8.5 and 8.6 inches
- 30 spline axle shaft fitment
Wiring a 12 volt locker
An electric locker trades hoses for wiring, so the electrical plan matters as much as the gears. Run the power feed from a fused source that switches on with the ignition or a dedicated relay, and keep the wire clear of moving suspension parts and hot exhaust. Place the switch where it is easy to reach while seated and where it will not catch on gear or trail debris.
Electric lockers usually operate in short engagements, so lock only when grip is needed and return to open for street driving. Connections should be sealed against water and checked after a few trail runs, since a loose or corroded terminal is a common cause of intermittent operation.
- Use a fuse close to the power source
- Route wiring away from heat and moving parts
- Seal connectors against water
- Check the switch and connections after trail use
Specifications
| Brand | Eaton |
|---|---|
| Part number | 19659-010 |
| UPC | 70000222859 |
| Axle manufacturer | GM |
| Axle location | Front and rear |
| Axle types | GM 10 Bolt 8.5 inches and GM 10 Bolt 8.6 inches |
| Axle spline | 30 splines |
| Locker type | E-Locker, push button selectable |
| Power | 12 volt |
Vehicle fitment
Match your axle to the GM 10 Bolt 8.5 inch or 8.6 inch type with 30 splines, in front or rear position. Axle size and spline count decide compatibility, so measure before buying. Verify the year, model and trim against your vehicle before buying.
Confirm your vehicle’s year, model and trim before ordering. Axle size and spline count decide compatibility, so measure before buying.
Installation notes
Fitting an E-Locker means pulling the carrier, installing the unit and setting ring and pinion backlash. A shop with gear setup experience should handle it. Route the 12 volt feed and the switch wiring before the carrier goes back in.
What’s included
Covered here: the E-Locker unit, part number 19659-010.
Not included: Plan for a switch, wiring harness, ring gear and pinion, and check which of these you need before starting.










