Overview
The Eaton E-Locker, part number 19977-010, is an electronic push-button selectable locker for Dana 44 axles with 30 splines. It fits the rear or front axle location. It moves the differential from open to spool with a button press, so it uses no air lines that could leak and no cables that could snag on the trail. It needs only 12 volt power to run.
It suits Dana 44 owners who want locking traction they can switch on from inside the vehicle. No specific vehicles or model years are named, so the axle housing and spline count are the main checks before buying.
Key features
- Electronic push-button selection between open and spool modes
- No air lines to leak and no cables to get hung up
- Runs on 12 volt power alone
- Built for Dana 44 axles with 30 splines
- Fits rear or front axle location
- Selectable locker differential type
Using a selectable locker
A selectable locker gives you control over when both wheels are driven together. Keep the differential open for daily driving and street use, then switch to spool when the trail calls for it. Unlock again before tight turns on hard surfaces so the tires scrub less and the drivetrain stays happier.
Wiring deserves attention because the switch and harness are the parts most likely to be disturbed over time. Route the wire away from moving suspension parts and heat sources, and secure it with clips. Check the switch and connections whenever you inspect the axle, and keep the connector sealed against water and mud.
- Keep the wiring clear of suspension travel
- Check the connector for corrosion each season
- Test the switch before a trail run
- Carry a spare fuse for the locker circuit
Specifications
| Brand | Eaton |
|---|---|
| Part number | 19977-010 |
| UPC | 432456901 |
| Locker type | Electronic selectable (E-Locker) |
| Actuation | Electronic push button |
| Power | 12 volt |
| Axle type | Dana 44 |
| Axle spline count | 30 splines |
| Axle location | Rear or front |
| Axle manufacturer | Dana |
Vehicle fitment
It is made for Dana 44 axles with 30 splines in rear or front location. Match your axle housing and spline count before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installing a locker means opening the axle, which is shop work for most owners. Connect the E-Locker only to the 12 volt supply Eaton describes, and disconnect the battery before working on any wiring.
What’s included
Look over the wiring, switch and hardware against your installation before starting.











