Overview
The Crown Automotive 52088808AB is a rear upper arm ball joint that directly replaces the factory joint. It fits the 1999–2004 Jeep Grand Cherokee (WJ) in the Laredo, Limited, Overland, Special Edition and Sport trims.
It is a factory-style replacement part. The joint is marked for the rear upper position and for a Dana 30 TJ front axle location, so confirm which position your vehicle needs before ordering.
Key features
- Directly replaces the factory joint
- Factory-style replacement part
- Rear upper position
- Fits the Jeep Grand Cherokee WJ.
- Crown Automotive part number 52088808AB
When to replace a ball joint
A ball joint is the pivot between the control arm and the steering knuckle. It carries suspension load while letting the wheel steer and travel up and down. On a Grand Cherokee WJ, the upper joints work with the arm bushings and the rest of the linkage, so wear in one joint often shows up as looseness across the whole assembly. Worn joints can cause vibration, uneven tire wear and a clunk over bumps.
When a joint is replaced, inspect the others, the bushings and the boot condition at the same time, since an aging suspension rarely wears one part alone. Match the new joint’s stud and taper to the knuckle, and seat the joint fully before tightening. Have the alignment checked after the work and re-check fasteners after the first few drives.
- Play felt when the wheel is lifted and checked
- Torn or cracked dust boot
- Clunking over bumps or uneven tire wear
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52088808AB |
| UPC | 848399039641 |
| Position | Rear upper |
| Axle location | Front |
| Axle type | Dana 30 TJ |
Vehicle fitment
It fits 1999–2004 Jeep Grand Cherokee (WJ) models in the Laredo, Limited, Overland, Special Edition and Sport trims.
Check your year, model and trim against the years and trims above before ordering.
What’s included
The package contains one ball joint. Check the package contents against your installation before starting.









