Overview
The Crown Automotive J8121391 is a lower ball joint nut for the front driver or passenger side. It fits Dana 30 standard or Dana 44 front axles on 1981–1988 Jeep CJ5, CJ7, J10, J20 and Scrambler models.
The nut is made for the front driver or passenger side position, with UPC 848399066920.
Key features
- Lower ball joint nut
- Front driver or passenger side
- For Dana 30 standard or Dana 44 front axles
- Crown Automotive part number J8121391
Securing the lower joint
The lower joint carries the weight of the front wheel through the lower control arm, so the nut must hold the stud firmly. Check the stud threads before fitting the new nut, and make sure the nut seats fully without binding. A nut that stops short of the torque target or spins on the stud should be replaced rather than forced.
Many castle-style nuts use a cotter pin through the stud to keep the nut from backing off. Confirm whether your joint uses a castle nut or a locking nut, and replace any cotter pin you remove rather than reusing a bent one. Torque the nut to the factory service manual value once the joint is fully seated.
- Check stud threads before fitting
- Seat the nut fully without binding
- Replace any bent cotter pin
- Torque to the factory service manual value
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8121391 |
| UPC | 848399066920 |
| Axle location | Front |
| Axle type | Dana 30 standard or Dana 44 |
| Position | Driver or passenger side |
Vehicle fitment
It fits the 1981–1983 CJ5 Base, Laredo, Limited and Renegade; the 1981–1986 CJ7 in the same trims; the 1981–1988 J10 and J20 Base; and the 1981–1985 Scrambler Base, Laredo, Renegade, SL and SR.
Other years and models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the position is the driver or passenger side, and that the axle is a Dana 30 standard or Dana 44, before fitting the lower nut.
What’s included
One nut, with no other parts included.









