Overview
The Crown Automotive J8121364 is an upper ball joint nut for the front driver or passenger side. It fits Dana 44 or Dana 30 standard front axles and the 1981–1988 Jeep CJ5, CJ7, J10, J20 and Scrambler.
It is a front driver or passenger side part.
Key features
- Upper ball joint nut
- Front driver or passenger side
- For Dana 44 or Dana 30 standard front axles
- Crown Automotive part number J8121364
Upper joint replacement tips
The upper ball joint nut holds the joint stud in the steering knuckle, so it carries load every time the wheel turns and the axle flexes. Threads that are stretched, rusted or damaged can let the stud loosen, and a worn nut is a good reason to replace it along with the joint.
Before installing, check the stud threads and the castle of the nut for damage, and make sure the cotter pin hole lines up when the nut is tightened. Upper and lower joints on a Dana 44 or Dana 30 front axle often wear at similar miles, so inspect both before deciding what to replace.
- Inspect the stud threads for rust or damage
- Replace the cotter pin rather than reusing it
- Look for play or clunking at the upper joint
- Check tire wear for signs of steering looseness
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8121364 |
| UPC | 848399066906 |
| Axle location | Front |
| Axle type | Dana 44 or Dana 30 standard |
| Position | Driver or passenger side |
Vehicle fitment
It fits the 1981–1983 Jeep CJ5 (Base, Laredo, Limited and Renegade), the 1981–1986 CJ7 (same trims), the 1981–1988 Jeep J10 and J20 (Base), and the 1981–1985 Jeep Scrambler in its Base, Laredo, Renegade, SL and SR trims.
Other years and models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check whether the nut is for the driver or passenger side before fitting it to the upper ball joint on the front axle.
What’s included
One nut is included.









