Overview
The Crown Automotive 4761678 is a Dana 35 rear ring and pinion kit with a 3.73 ratio, made for Jeep Cherokee (XJ), Grand Cherokee (ZJ), Wrangler (TJ) and Wrangler (YJ) models. A ring and pinion set is the gear pair inside the rear differential that turns driveshaft rotation into axle rotation.
The 3.73 ratio means the pinion turns 3.73 times for each turn of the ring gear. It is a direct-fit part for the rear position, and it carries a 12 month/12,000 mile warranty.
The year range for your model matters more than the axle name alone, since the same axle appears across four Jeep model lines. The part is a rear direct fit, and the 12 month/12,000 mile warranty applies to it.
Key features
- Dana 35 rear axle ring and pinion set
- 3.73 gear ratio
- Rear position
- Listed by Crown as a direct fit
- Fits selected XJ, ZJ, TJ and YJ years, detailed in fitment.
Setup and break-in
A ring and pinion set works best when the pinion depth, backlash and bearing preload are set as a matched job. These settings control the tooth contact pattern, and an incorrect pattern leads to whine, heat and early wear. A transmission and axle shop with gear setup tools can check the pattern and make the final adjustments.
Before the swap, inspect the carrier bearings, the pinion seal and the differential case for wear, since replacing these while the gears are out can prevent a repeat repair. Use fresh gear oil suited to the axle, and expect a break-in period in which the gears settle. Listen for noise during the first drives and check the fluid level again after the first few drives.
- Set pinion depth and backlash
- Check the tooth contact pattern
- Replace worn carrier bearings
- Refill with fresh gear oil
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4761678 |
| UPC | 848399007848 |
| Axle | Dana 35 |
| Axle position | Rear |
| Gear ratio | 3.73 |
| Fit type | Direct Fit (per Crown) |
| Warranty | 12 month/12,000 mile (per Crown) |
Not stated by the manufacturer: the tooth counts, the material, and whether installation hardware or bearings are included.
Vehicle fitment
The rear Dana 35 axle is the fit, with years varying by model. Check your model’s year range before ordering.
The manufacturer fitment list for part 4761678 covers: 1994–1999 Jeep Cherokee (XJ); 1993–1998 Jeep Grand Cherokee (ZJ); 1997–2000 Jeep Wrangler (TJ); 1994–1995 Jeep Wrangler (YJ).
Not listed: Cherokee (XJ) outside 1994-1999, Grand Cherokee (ZJ) outside 1993-1998, Wrangler (TJ) after 2000, Wrangler (YJ) outside 1994-1995, and any Wrangler JK or JL. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A ring and pinion swap requires setting pinion depth and backlash and checking the tooth contact pattern, which is typically done by a transmission and axle shop. A new set also needs a break-in period.









