Overview
The Dana Spicer Dana 44 3.54 Ratio Ring and Pinion Kit, part number 706017-3X, is a 3.54-ratio gear set for Dana 44 front or rear axles.
The company says its ring and pinion sets come in most of the popular performance and replacement ratios, and that these gears match what the axle used from the factory.
Key features
- 3.54 gear ratio
- Dana 44 axle type
- Front or rear axle location
Before you buy
A ring and pinion sets the final drive ratio between the driveshaft and the wheels, so a change to the ratio changes how the vehicle accelerates, cruises, and pulls under load. Before buying, think about tire size, typical loads, and how often the vehicle sees highway speeds. A numerically higher ratio often feels stronger off the line, while a lower one can make highway cruising quieter. The right choice depends on the vehicle and how it is driven, so it helps to write down the current ratio and the axle’s carrier before comparing options.
Gears are usually replaced with matching pinion parts and bearings, and many installers replace the carrier bearings and pinion seal at the same time. Old gears that show pitting, chipped teeth, or a whine that changes with throttle position are signs the set is worn. Check the setup after a break-in period by listening for noise and checking for leaks.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 706017-3X |
| Axle type | Dana 44 |
| Gear ratio | 3.54 |
| Axle location | Front or rear |
Vehicle fitment
It fits Dana 44 axles in either the front or rear position and is not tied to one vehicle. Confirm the axle housing and current ratio before installing.
Installation notes
A gear set like this needs professional setup, including mesh and bearing preload, and a break-in period once installed.
















