Overview
The G2 Axle and Gear 2-2011-411 is a 4.11 ratio ring and pinion for the Ford 9 inch rear axle. It installs in the rear location and suits the Ford 9 inch axle type.
G2 describes its performance ring and pinion sets as built for oversized tires and high performance engines, using the latest technology and materials. A 4.11 ratio multiplies torque at the wheels more than a 3.89 ratio, which is useful with larger tires.
Key features
- 4.11 ratio rear ring and pinion
- Ford 9 inch rear axle type
- Intended for oversized tires and high performance engines.
- Built with the latest technology and materials.
Ratio and larger tires
A 4.11 ratio is a numerically higher gear than the 3.89 option, so it multiplies torque at the wheels more. That helps a vehicle carrying bigger tires pull away and climb, though engine speed at highway cruising rises to match.
Make sure the ratio is chosen with the tire diameter in mind, since larger tires already lower the effective gearing. Pinion depth, backlash and preload are set by a driveline shop, and the axle bearings and seals should be inspected at the same time. Drivers who expect frequent highway use should weigh the extra engine speed against the low-speed benefit, since the choice affects both fuel use and everyday comfort.
- Compare tire diameter with ratio before buying
- Replace pinion bearing and seal during the job
- Inspect axle bearings for play before reassembly
- Check tooth contact after the break-in period
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2011-411 |
| UPC | 631410093421 |
| Gear ratio | 4.11 |
| Axle location | Rear |
| Axle type | Ford 9 inch |
| Popular axle manufacturer | Ford |
Vehicle fitment
This 4.11 set is built for the Ford 9 inch rear axle. Confirm the housing size and the vehicle’s year, model and trim before ordering.
Only the Ford 9 inch is named for this 4.11 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the 4.11 Ford 9 inch gears should be set by a driveline shop, then the set should go through a break-in period.
What’s included
A 4.11 ring and pinion set for the Ford 9 inch.
















