Overview
The G2 Axle and Gear CORE 44 rear axle assembly, part number C4TSR488AC0D, is a complete Dana 44 rear axle with a 4.88 gear ratio, an ARB Air Locker and a disc brake kit. It is built for 1997-2006 Jeep TJ and 2004-2006 Jeep LJ Wranglers.
G2 designed the housing to carry heavy loads that would bend a stock Dana 30 or a Rubicon Dana 44. It uses a high pinion layout built on what G2 calls its strongest and latest generation Dana 44 gear design, and it accepts stock ring and pinions, axle shafts and aftermarket lockers.
Key features
- High pinion Dana 44 gear design, G2’s latest generation
- Accepts stock Dana 44 ring and pinions and axle shafts
- Aftermarket lockers can also be fitted.
- 4.88 gear ratio paired with an ARB Air Locker
- Disc brake upgrade for the rear axle
- 30-spline axle shaft spline, rear position
Disc brake upgrade considerations
Switching to a disc brake setup at the rear touches more than the axle. Rotors, calipers, pads and brackets need to match the hub and backing plate, and the brake lines, master cylinder capacity and any proportioning valve should be checked for the new layout. The parking brake also needs to be set up so it still holds the vehicle when parked.
The housing takes stock Dana 44 ring and pinions, and an ARB Air Locker is fitted, so gearing and braking can be sorted in one shop visit. Ask the installer to confirm the wheel bearing and hub arrangement, and check that the ABS sensor wiring, if equipped, still reaches its mounting point.
- Confirm brake lines and fittings match the new calipers
- Check the parking brake after the swap
- Bed in new pads before heavy use
- Keep brake fluid fresh during installation
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4TSR488AC0D |
| UPC | 631410134865 |
| Housing type | 97-06 Jeep TJ Dana 44 |
| Front or rear | Rear |
| Axle spline | 30 splines |
| Gear ratio | 4.88 |
| Traction device | ARB Air Locker |
| Brakes | Disc brake upgrade |
| Wheel bolt pattern | 5 on 4.5 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1997-2006 Jeep TJ/LJ Wranglers: the 1997-2006 Jeep TJ and 2004-2006 Jeep LJ.
Other Wrangler generations, including YJ, JK and JL models, and Cherokee models are outside this housing’s stated coverage. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the housing takes stock Dana 44 ring and pinion sets and axle shafts, an existing gear set can be carried over. Gear mesh and bearing preload still need a shop equipped for ring and pinion setup, and incorrect mesh can cause rapid gear damage, so verify the setup before driving.
What’s included
The assembly comes with an ARB Air Locker and a disc brake kit.
Not included: Ring and pinion gears and axle shafts are not included; the housing accepts stock Dana 44 parts.



















