Overview
The G2 Axle and Gear JK CORE 44 rear axle with a 4.88 ratio and ARB Air Locker (part C4JSR488AP5) is for 2007 and newer Jeep Wrangler JK models. It is built around a Dana 44 JK 8.8-inch gear design inside a new housing that G2 says is meant to handle loads that would normally bend a stock Dana 30 or Rubicon Dana 44.
The housing is set up for lockers of the owner’s choice. The shafts are USA-made Placer Chromalloy units with 35 splines, and the axle is a direct fit that reuses the factory wheel ends and brakes.
Key features
- Dana 44 JK 8.8-inch gear design in a new housing
- ARB Air Locker
- USA-made Placer Chromalloy axle shafts with 35 splines
- Designed to take aftermarket lockers of the owner’s choice
- Reuses factory wheel ends and brakes
Using a locker on the trail
An air locker locks the two rear wheels into one speed, so the wheel with grip keeps the vehicle moving. Drivers new to lockers should practice on low-traction ground to learn how the vehicle turns with the locker engaged.
Lockers cause tight turning on pavement, which can wear tires and stress the drivetrain. Disengage the locker before driving on hard surfaces, and check the engagement at the start of every trail day.
Tire size, gearing and locker choice are linked, so a change to one usually means checking the others. A 4.88 ratio with a locker suits slow crawling, and a shop familiar with Dana 44 rears can help confirm the setup before a trip.
- Disengage the locker on pavement
- Practice engagement on low-traction ground
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4JSR488AP5 |
| UPC | 631410121001 |
| Position | Rear |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.88 |
| Traction device | ARB Air Locker |
| Axle spline | 35 splines |
| Axle shafts | Placer Chromalloy, USA made, 35 spline |
| Wheel ends | Reuse factory |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
This rear axle is built for the 2007–2018 Jeep Wrangler JK generation.
Before buying, confirm your year, model and trim, especially for TJ, LJ or JL Wranglers, since this axle is designed for the JK.
Installation notes
A 4.88 gear set with a locker needs professional setup and break-in on a Dana 44. Because the factory wheel ends and brakes are reused, confirm the 35-spline shafts match the hubs in use before fitting.
What’s included
The complete rear axle assembly with the 4.88 gear set and ARB Air Locker.
















