Overview
The G2 Axle and Gear CORE 44 front axle with a 4.10 ratio and Eaton E-Locker is a complete Dana 44 front axle for 1997-2006 Jeep Wrangler TJ and 1984-2001 Jeep Cherokee XJ models. G2 built the housing to handle loads that would bend a stock Dana 30 or a Rubicon Dana 44.
The housing accepts stock Dana 44 ring and pinion gears, axle shafts and aftermarket lockers. The front axle uses a new generation JK 44 ring and pinion, and it comes with 30 spline G2 chromoly axles.
The housing is built for heavy use. Heavy duty forged bearing caps hold the carrier, spanner nuts set the backlash, and a heat-treated aluminum differential cover with cooling fins covers the gears. Integrated skid plates on the lower control arm mounts and reinforcing ribs add protection to the housing.
Key features
- Forged inner C-ends and skid plates on the lower control arm mounts
- 1/4 inch laser cut brackets and 3 inch diameter, 5/16 inch DOM tubes
- Reinforcing ribs and heavy duty forged bearing caps
- Spanner nuts for backlash adjustment
- Heat-treated aluminum differential cover with cooling fins
- New generation JK 44 ring and pinion
Axle swap considerations
Replacing a complete front axle changes more than the axle itself. Pinion angle, driveline length and steering geometry all depend on the axle position, and a new housing can shift those angles. Once the axle is in, check the driveshaft angles and the steering alignment, and recheck them after any lift change or tire upgrade.
Locking differentials change how the vehicle behaves on the trail, because a locker drives both wheels together and can feel abrupt on pavement. Regular lubrication of the gears, a check of the axle seals and periodic inspection of the axle shafts help protect the new housing. A front axle upgrade is often paired with a steering and brake check, since wheel and brake components may need matching adjustments.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| UPC | 631410132847 |
| Position | Front |
| Housing | Dana 44, 97-06 TJ and 84-01 XJ |
| Gear ratio | 4.10 |
| Locker | Eaton E-Locker |
| Axle spline | 30 spline |
| Bearings | SAE |
| Wheel bolt pattern | 5 on 4.5 inches |
| Brakes | Reuse factory |
| Fitment type | Direct fit |
Vehicle fitment
This axle is built for the 1997-2006 Jeep Wrangler (TJ), including the Rubicon and Unlimited versions, and for the 1984-2001 Jeep Cherokee (XJ).
It is not made for the Wrangler (JK) or the Grand Cherokee. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Swapping in a complete front axle means checking alignment and driveline angles afterward, and lift height changes both.
What’s included
The assembly includes 30 spline G2 chromoly axle shafts and the Eaton E-Locker.
Not included: the factory brake parts, which are reused.

























