Overview
The G2 Axle and Gear JK CORE 44 front axle with a 4.88 ratio and ARB Air Locker (part C4JMFS488AP5) is for 2007 and newer Jeep Wrangler JK models. G2 uses a high pinion 8.8-inch Dana 44 gear design in a new housing built for heavy loads.
The housing is designed to carry lockers and other aftermarket parts of the owner’s choice. The axle uses USA-made G2 Placer Gold 35-spline Chromalloy shafts, and it is a direct fit that reuses the factory wheel ends and brakes. The 35-spline shafts pair with the ARB Air Locker in this assembly.
Key features
- High pinion 8.8-inch Dana 44 gear design
- ARB Air Locker
- USA-made 35-spline Chromalloy axle shafts
- Standard axle caster for 0 to 4 inch lifts
- Heavy-duty 3-inch diameter, 5/16-inch DOM tubes with reinforcing ribs
- Massive forged inner C-ends and integrated skid plates on the lower control arm mounts
- Metric Rubicon-style carrier bearings and forged bearing caps
- Spanner nuts for backlash adjustment
- Heat-treated aluminum differential cover with cooling fins
Setup after installation
A 4.88 ratio is steeper than many lower ratios, so the vehicle pulls strongly at low speed but turns the engine faster on the highway. Many owners pair a ratio like this with larger tires only after checking the speedometer and the overall gearing, since the change affects how the transmission and transfer case work together.
Gears and a locker on a Dana 44 are usually set up during installation. Backlash and pattern checks are part of that work, and the spanner nuts make backlash adjustment possible. After the first drives, re-check the bolts on the cover and look for seal leaks around the axle ends.
Locker engagement should be practiced on a flat, low-speed surface before harder off-road use, so the feel of the axle is familiar. Keep a note of any unusual noise, since early warning signs are easier to fix than a failed gear set.
- Re-check axle bolts after the first drives
- Watch for seal leaks at the axle ends
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4JMFS488AP5 |
| UPC | 631410120370 |
| Position | Front |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.88 |
| Traction device | ARB Air Locker |
| Axle spline | 35 splines |
| Axle shafts | USA-made 4340 Chromalloy, 1.5 inch, 35 spline |
| Axle tubes | 3 inch diameter, 5/16 inch DOM |
| Wheel bolt pattern | Reuse factory ends |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
This axle is built for 2007 and newer Jeep Wrangler JK models, within the 2007–2018 range for that generation.
Make sure your vehicle’s year, model and trim match before you buy, since this axle is built for the JK generation.
Installation notes
The factory wheel ends and brakes are reused, so the fitting is an axle-only job. A 4.88 gear set with a locker calls for professional setup and break-in. Backlash is adjusted with the spanner nuts that G2 includes, and the forged inner C-ends and skid plates are part of the housing rather than add-ons. Confirm the front position and 35-spline shafts match your vehicle before ordering.
What’s included
The complete front axle assembly with the 4.88 gear set, ARB Air Locker and 35-spline Chromalloy shafts.



















