Overview
The TeraFlex 1958000 is a set of Alpine long arm frame-end brackets for the 2018–2026 Jeep Wrangler JL 4-door. The brackets are made for 3 to 6 inch lifts and reposition the frame-end control arm mounting points to restore a near factory orientation.
The brackets are CAD designed for strength and combine the upper and lower mounts in one bracket, which simplifies installation while keeping a factory appearance. The kit is brackets only, so the long control arms are bought separately.
Key features
- Upper and lower mounts in each bracket
- Streamlined frame-end mounting points
- Restores near factory control arm orientation on higher lifts
- Reduces bushing stress during droop and shock load.
- Can be added to an existing suspension lift
Long arm geometry on lifted Wranglers
Long arm kits change the geometry at the axle, so the caster and anti-squat settings shift as the lift changes. Lifted Wranglers that run longer control arms often keep better wheel travel and a calmer ride than short arm setups at the same height. The brackets reposition the frame-end mounts, which helps keep the arm angles closer to stock.
Once the arms and brackets are installed, the alignment should be checked by a shop that can measure caster and thrust angle. Check the bushings and bolts after the first few trail runs, since new geometry can load components differently. Keep the steering linkage and the driveline angles in mind, because changing the arm position can affect both.
- Caster and thrust angle alignment
- Re-check bolts after early trail use
- Watch driveline angles after the lift
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1958000 |
| Lift range | 3 to 6 inch |
| Contents | Brackets only |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler JL in the Unlimited Moab, Unlimited Rubicon, Unlimited Sahara and other covered 4-door trims.
The 2-door JL and the JK are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets must be used with adjustable Alpine IR long control arms, part 1310505, or adjustable Alpine long control arms, part 1316005. Those arms set the caster angle and anti-squat geometry for proper alignment on Wrangler Unlimited models with 3 to 6 inch lifts. The long control arms are not included.
What’s included
The Alpine long arm brackets only. The Alpine IR long control arms are not included.






