Overview
The Rough Country Front Control Arm Relocation Brackets, part number R/C110602, are bolt-on brackets that drop the factory control arm angles by 3 inches on a lifted Jeep Wrangler JL or Gladiator JT. They are designed for 3.5 inches of lift with stock control arms. They are a direct fit for the 2018 to 2026 Jeep Wrangler JL and 2020 to 2026 Jeep Gladiator JT trims named in the fitment.
A steeper control arm angle pushes the force of a bump up into the springs rather than into the frame. Reducing the operating angle keeps the arms closer to stock geometry, which supports a more comfortable ride on the trail and more controlled braking. The brackets are built around that goal.
Lifting a Jeep changes the front control arm angles. The brackets move the arm mounting points to bring those angles back toward factory geometry, which also improves driveshaft angle.
Key features
- Drops factory control arm angles by 3 in.
- Bolt-on installation
- Designed for 3.5 in. of lift with stock control arms.
- Improves driveshaft angle.
- Direct fit for JL and Gladiator trims
- Part number R/C110602
Control arm angles explained
Control arm angle is the slope of each arm when the vehicle sits at ride height. When a lift raises the body, the arms usually tilt more steeply, and that change shifts how the suspension loads under bumps and braking. Keeping the angle close to factory helps the springs and bushings work in the range they were designed for. Much of the benefit comes from the geometry itself.
Driveshaft angle is tied to the same change. A lifted Jeep often runs a steeper driveshaft angle, which can add vibration at speed and wear the u-joints sooner. Shops usually measure pinion and transfer case angles together, so a front arm change may call for a driveline check as well.
- Check arm bushings for wear or cracking at regular service intervals
- Re-torque fasteners after the first few highway and trail drives
- Look for vibration at highway speeds, which can point to driveline angle
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C110602 |
| Drop | 3 in. to factory control arm angle |
| Lift | 3.5 in. with stock control arms |
| Mounting | Bolt-on |
| Fit | Direct fit |
Vehicle fitment
The brackets fit 2020 to 2026 Jeep Gladiator models, including High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims. They also fit 2018 to 2026 Wrangler JL two-door and four-door models in many trims, including Rubicon, Sahara, Sport, Moab and Willys.
Wrangler JK and TJ models are not in this fitment, and the brackets are designed for about 3.5 inches of lift. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets bolt on in place of the factory mounts with the stock control arms. Have the alignment and driveshaft angles checked after installation.
What’s included
The front control arm relocation brackets. Check the package contents against your installation before starting.





