Overview
The TeraFlex 1968352 is a 2-inch stroke SpeedBump and progressive bump stop kit for the 2020–2026 Jeep Gladiator. It is sized for a 2.5 to 3.5 inch lift and adds protection beyond the factory bump stops. It fits the Gladiator in its Launch Edition, Mojave, Overland, Rubicon, Sport and Sport S trims.
The composite construction and progressive design reduce compression impacts and harshness when the suspension bottoms out, on the trail or on rough highways. The stops are maintenance free and need no adjustment or tuning. The reduced impact helps the driver keep control and lowers the risk of bending an axle housing tube.
Key features
- 2 inch stroke SpeedBump stops
- Progressive stops made of nitrogen charged microcellular polyurethane
- Progressive stops are 1.5 inch longer than stock
- Delrin acetal resin polymer shaft that is self-lubricating
- Maintenance free with no adjustment needed
- Composite construction for progressive compression control
- External shaft seal wipes and cleans the shaft
- Lower SpeedBump strike pads bolt on
Choosing and checking stop length
Bump stop length decides when the suspension stops compressing and how much load the axle housing and shocks take at the end of travel. A progressive stop softens the final part of compression, so the impact is spread out instead of hitting hard. Length must match the lift, so confirm the stop engages at the intended height after any suspension change.
Composite progressive stops are often used alongside a shock or spring change. Check the shock length, brake line slack and steering clearance at full compression, and confirm the stops sit in their locations. Inspect the stops at each service for splits, tears or loose mounting, since the surface can wear under heavy use.
- Check stop length against your lift height
- Inspect shocks and brake lines at full compression
- Look for tears or splits in the composite stops
- Confirm the stops sit fully in their locations
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1968352 |
| Stroke | 2 inch |
| Lift range for the kit | 2.5 to 3.5 inch lift |
| Progressive stop length | 1.5 inch longer than stock |
| Shaft | Delrin acetal resin, self-lubricating |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator in its Launch Edition, Mojave, Overland, Rubicon, Sport and Sport S trims.
Wrangler models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The front SpeedBump stops require removal of the factory bump stop bell, and the progressive stops pop into the existing factory locations. The lower SpeedBump strike pads bolt on. The stops pop into the existing factory locations, so no new mounting points are needed. Proper bump stop length and strike pad height are important for preventing damage to axle housing tubes, suspension components, shock absorbers and fenders, so check stop height for clearance after installation. The progressive stops keep their flexibility at sub-zero temperatures and are built to hold their progressive nature under extended heavy use.









