Overview
The TeraFlex 1958352 is a 2-inch stroke SpeedBump and progressive bump stop kit for the 2018–2026 Jeep Wrangler JL in its 2-door and 4-door trims. The kit adds protection beyond the factory bump stops, which can deform during hard compression and suspension movement.
The composite construction and progressive design are intended to reduce impacts and harshness when bottoming out, on the road or off it. The stops are maintenance free and need no adjustment or tuning. An external shaft seal is designed to keep contaminants out of the SpeedBump housing.
Key features
- 2 inch stroke SpeedBump stops for the front and rear
- Progressive bump stops made of nitrogen charged, closed-cell microcellular polyurethane
- Progressive stops are a full 1.5 inch longer than stock
- Self-lubricating Delrin acetal resin shaft on the SpeedBump stops
- External shaft seal that wipes and cleans the shaft
Stop length and axle protection
Bump stops control the final part of suspension travel, which is where axle housing tubes, shocks and fenders are most exposed to impact. Progressive designs increase resistance as they compress, so the suspension is not stopped abruptly. Stop length and strike pad height set when that resistance begins, so they should match the lift and tires in use.
Microcellular polyurethane and self-lubricating shafts are designed for repeated use, but the seals and shaft surfaces still need occasional inspection. Look for torn seals, grit on the shaft, cracks in the stop and loose hardware. Clean away mud and debris after off-road trips to keep the shaft moving freely.
- Inspect the external shaft seal for tears
- Wipe grit from the shaft after trail use
- Check strike pad height after changing tires
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1958352 |
| Type | Air bump |
| Stroke | 2 inch |
| Progressive stop length | 1.5 inch longer than stock |
| Shaft | Self-lubricating Delrin acetal resin on SpeedBump stops |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler JL in 2-door 80th Anniversary, Freedom, Islander, Rubicon, Sport and Sport S trims, and in 4-door 80th Anniversary, Freedom, Islander, Moab, Rubicon, Rubicon 392, Sahara, Sport, Sport S and Willys trims, along with 2-door Willys and Willys Sport trims.
Wrangler JK and Gladiator models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The front SpeedBump stops require removal of the factory bump stop bell. The progressive stops pop in to the existing factory locations, and the lower SpeedBump strike pads bolt on. Proper bump stop length and strike pad height protect the axle housing tubes, suspension components, shocks and fenders, so check clearance after installation. The front and rear stops use a bolt-on installation.









