Overview
The TeraFlex SpeedBump Bumpstop Kit, part number 1958401, is a set of front composite bumpstops sized for a 4 inch lift on the Jeep Wrangler JK. It is designed as a progressive bumpstop that cushions the suspension at the end of its travel. The kit is sold as a pair and fits 2007–2015 Jeep Wrangler (JK) models.
Bumpstops of this type absorb the energy of harsh compression on rough trails and poorly maintained pavement. Absorbing those impacts is intended to reduce the risk of axle housing bends and help the driver keep control of the vehicle. The bolt-on design replaces the factory bumpstop bell at the front, so the front end can be upgraded without cutting or welding.
Key features
- Progressive composite bumpstop design that builds resistance as the suspension compresses
- Closed-cell nitrogen charged microcellular polyurethane construction
- Designed to hold its flexibility in temperature extremes, including sub-zero conditions.
- Delrin acetal resin polymer shaft that is self-lubricating
- External shaft seal that wipes and cleans the shaft to keep contaminants out of the housing
- Maintenance free operation with no custom adjustment or tuning required
- Bolt-on installation with no welding required
Front-end bumpstop care
The front bumpstop is the stop that meets the axle when the suspension is pushed to full compression on a steering turn or a hard landing. When the factory bell is replaced, the new stop sets the limit of compression at the front, so its engagement point should be checked with the steering turned both ways. Front stops also sit close to steering linkage and brake lines, so clearance matters as much as the stop itself.
Owners who run a wide range of tire sizes should expect stop engagement to shift. Re-check travel and clearance after any change to tires, shocks or springs. Periodically wipe the shaft seal and look for tearing that lets grit into the housing. A worn seal can let the shaft bind, which changes how the stop compresses.
- Check clearance at full steering lock
- Inspect the seal and shaft after mud or sand use
- Look for rub marks on the axle or steering components
- Keep the strike pads clean and tight
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1958401 |
| UPC | 843885025139 |
| Position | Front |
| Lift height | 4 inch |
| Bumpstop body material | Closed-cell nitrogen charged microcellular polyurethane |
| Shaft material | Delrin acetal resin polymer |
| Sold as | Pair |
Vehicle fitment
It is a direct fit for 2007–2015 Jeep Wrangler (JK) models, including Unlimited versions and trims such as Rubicon, Sahara, Sport and X, along with the 70th Anniversary editions. Front bumpstops for other Wrangler generations are a different part.
This kit is for the JK generation; the earlier TJ and LJ and the JL are different vehicles. Check year, model and trim against this kit before ordering.
Installation notes
The front installation replaces the factory bumpstop bell, so the bell must be removed before the SpeedBump is fitted. No welding is required. Support the vehicle on jack stands before removing any factory suspension parts.
What’s included
The kit includes two front SpeedBump bumpstops, front adjustment spacers and front lower bumpstop strike pads. It is sold as a pair.









