Overview
The TeraFlex 1969200 is a progressive bump stop kit for the 2020–2021 Jeep Gladiator in its Overland, Rubicon, Sport and Sport S trims. The kit replaces the factory foam bump stops with progressive microcellular polyurethane stops that absorb impact energy as the suspension compresses, which TeraFlex says helps prevent bent axle tubes.
The kit fits models with 0 to 4.5 inch of lift and is tuned for the JT. The stops are closed-cell and charged with nitrogen, and they run quiet, without the pad-slap clunk that some bump stops make.
Key features
- Progressive absorption of large impacts during compression
- Replaces the factory foam bump stops
- Closed-cell, nitrogen charged microcellular polyurethane
- Quiet operation with no pad-slap clunk.
- All-composite, maintenance-free construction
Stop length and axle protection
Bump stops protect the axle tubes, shocks and fenders at the end of compression, and their length controls when that protection begins. Stops that are too short let the suspension strike hard parts, while stops that are too long can change the way the suspension rides. Measure the clearance at full compression after installation to confirm the stops engage in the right place.
Microcellular polyurethane is a common choice for bump stops because it can absorb energy and recover its shape over time. Dirt, salt and water can still work into the mounting areas, so wipe the stops and pad surfaces during regular service. Check the factory locations and strike pads for wear before reinstalling stops after a suspension change.
- Confirm clearance at full compression
- Wipe stops and pad surfaces during service
- Check factory mounting locations for wear
- Replace stops that show tears or crumbling
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | TER1969200 |
| Type | Air bump |
| Material | Nitrogen charged microcellular polyurethane |
| Lift range | 0 to 4.5 inch |
| Maintenance | Maintenance free |
| Warranty | Limited lifetime |
| Fitment | Direct fit |
Vehicle fitment
The kit is a direct fit for the 2020–2021 Jeep Gladiator in its Overland, Rubicon, Sport and Sport S trims.
Gladiator model years outside 2020 and 2021 and the Wrangler are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stops pop into the existing factory locations, so no new mounting points are needed. They fit suspension setups that keep the factory axle spring mounting locations. Stop length is important, because correct length and strike pad height protect axle tubes, suspension components, shocks and fenders. The stops absorb large impacts progressively during compression, keep their progressive action under heavy use, and are unaffected by temperature extremes. They resist mud, salt, sand and dust.
What’s included
A set of progressive microcellular bump stops for the Gladiator. Installation is a simple bolt-on job.









