Overview
The TeraFlex 1954802 is a pair of 2 in. tall bumpstop pads for fine-tuning the final bumpstop length on a suspension. Their purpose is to keep your shocks from bottoming out and your tires from contacting the fenders.
Final bumpstop length is central to that protection, and these pads let you set it instead of relying on a fixed stop height. Check fit against your vehicle’s year, model and trim before ordering.
Key features
- Allows fine tuning of final bumpstop length
- Pads are 2 in. tall
- Supplied as a pair
- Intended to prevent shock bottoming and tire-to-fender contact
Choosing a bumpstop setup
Bumpstops work at the very end of suspension travel, where the shock and axle reach their limit. A stop that sits too short lets the shock bottom out harshly, while one set too long can allow the tire to rub the fender or the axle to strike the frame. Adjustable pads like these give you a way to position the stop once the lift and tire size are in place, rather than accepting a fixed height that may not match your build.
When you choose how tall to go, think about the whole system. Taller tires, longer shocks and changed control arm angles all move where full compression happens. Re-check travel after each of those changes, because a bumpstop that worked before a tire upgrade may no longer clear. Set the pads with the vehicle at ride height, then cycle the suspension slowly by hand to feel where contact begins.
Over time, rubber and urethane stops can compress, crack or pick up grit. Inspect them during routine service and replace any that look split, flattened or loose. A pad that has shifted can move the contact point off center, so confirm it still seats square before every trail season.
Specifications
| Brand | TeraFlex |
|---|---|
| Part number | 1954802 |
| UPC | 843885025009 |
| Height | 2 in. (tall) |
| Quantity | Pair |
| Product type | Bumpstop pad |
Vehicle fitment
It is a direct fit bumpstop. Fit still depends on year, model and trim.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check shock and tire clearance at full compression after setting the pads rather than assuming the stop height is correct.
What’s included
A pair of 2 in. tall bumpstop pads.









