Overview
The JcrOffroad Crusader Rock Sliders, part number XJSL-CR-BARE, are bare steel rocker guards for the 1984–2001 Jeep Cherokee (XJ), in both 2-door and 4-door body styles. The sliders form to the body and protect the lower rocker area from rocks and ledges.
The Crusader is designed to be a lighter, higher-clearance option than standard boxed tube sliders, adding more than 2 inch of ground clearance and weighing nearly 20 lb less. The design accommodates most fender cuts, though trimming the factory flares is needed for a proper fit.
Key features
- Formed from 3/16 inch steel box tubing and round tube, CNC formed in the USA
- Mounts into the rocker, the pinch seam and the main uniframe with 35 fasteners per side
- Form fitted to the body with a tubular standoff design
- Claimed ground clearance gain of more than 2 inch over boxed tube sliders
- Bare steel finish, made in the U.S.A.
Fender trimming and clearance
Trimming fender flares is the step that decides how much clearance you get. The slider sits lower and closer to the wheel than the body originally did, so the flare edge and any fender liner may need to be cut back. Make small trims, test fit often, and remove only what is needed to avoid rubbing at full steering lock.
Lighter guards are easier to handle during install, but the mounts still carry real weight once the slider is bolted on. Use a helper or a floor jack to hold the guard while you start fasteners, and keep the vehicle on stands during all drilling. Check the uniframe and rockers for rust before fitting, since a weak mounting area reduces what the slider can resist.
- Test fit before drilling any final holes
- Deburr cut edges on the flare trim
- Check tire clearance at full lock and full travel
Specifications
| Brand | JcrOffroad |
|---|---|
| Part number | XJSL-CR-BARE |
| UPC | 780456973027 |
| Finish | Bare steel |
| Material | 3/16 inch steel box tubing and round tube |
| Type | Formed plate guard with tubular standoff |
| Installation type | Cutting or drilling required |
| Fasteners | 35 per side |
| Combined weight, both sliders and mounts | Approximately 90 lb |
| Fitment | Direct fit |
Vehicle fitment
JcrOffroad lists these sliders for the 1984–2001 Jeep Cherokee (XJ) in the following trims: Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport.
It fits the 1984–2001 Jeep Cherokee XJ. Confirm fit for your vehicle’s year, model and trim before ordering, particularly if you own a ZJ or WJ Grand Cherokee or a KJ Liberty.
Installation notes
- Drilling is required, and the factory flares must be trimmed for a proper fit.
- Aftermarket uniframe stiffeners will not work without longer hardware.
- Rubicon Express long arm kit owners must remove the pinch seam gusset plates.
- It works with Full Traction, Rough Country, TNT, Rustys, BDS, Rock Krawler and TeraFlex long arm kits. Check the fit against other long arm kits before installing.
- Any structural problem in the rockers reduces the strength of the sliders once installed.
Drill and cut with the vehicle securely supported on stands.
What’s included
Sliders for both sides with their mounts. JcrOffroad gives one combined weight of approximately 90 lb for both sliders and mounts.


















