Overview
The JcrOffroad Crusader Sliders, part number XJSL-CR-PC, are black powder-coated rocker sliders built for the 1984–2001 Jeep Cherokee (XJ), covering both two-door and four-door models. They guard the rocker panels between the wheels against rocks and ledges on the trail.
Compared with boxed tube sliders, the Crusader design gives up some strength for ground clearance. It adds more than 2 inch of ground clearance and weighs nearly 20lbs less than the boxed tube version. The sliders are CNC formed in the USA from 3/16 inch thick steel and mount with 35 fasteners per side, tying into the rocker, the pinch seam and the main uniframe.
Key features
- Tubular guard with tubular standoff, formed from 3/16 inch thick steel
- CNC formed in the USA with a black powder coat finish
- Mounts into the rocker, the pinch seam and the main uniframe with 35 fasteners per side
- Designed to accommodate most fender cuts; trimming of the factory flares is required for a perfect fit
- Designed for major long arm suspension kits, including Full Traction, Rubicon Express, Rough Country, TNT, Rustys, BDS, Rock Krawler and TeraFlex
- Strength depends on the condition of the Jeep’s rockers, and structural damage will weaken the sliders once installed.
Choosing a rocker slider
A slider works as a shield and as a stop for the Jeep’s body. Tubular designs trade some strength for clearance, so the rocker, pinch seam and uniframe have to be sound before they take the load. Trail hits concentrate at the leading edge, where bent or cracked tube should be checked after each outing.
Gaining ground clearance changes how the Jeep sits over obstacles and how much of the body is exposed to rock strikes. Decide between tube and boxed designs based on the trails you run most often, and consider how the sliders work with any long arm or uniframe upgrades already on the vehicle.
- Check the pinch seam for cracks before and after installation
- Look at tube dents and mounting bolts after rough trails
- Plan for trimming, fitting and drilling before the first install
- Keep the powder coat intact to slow corrosion on the steel
Specifications
| Brand | JcrOffroad |
|---|---|
| Part number | XJSL-CR-PC |
| UPC | 700007278641 |
| Finish | Black powder coat |
| Material | 3/16 inch thick steel |
| Construction | Tubular guard with tubular standoff, CNC formed in the USA |
| Mounting fasteners | 35 per side |
| Ground clearance | More than 2 inch gained compared with boxed tube sliders |
| Weight | Nearly 20lbs lighter than standard boxed tube sliders |
| Combined weight | Approximately 90lbs for both sliders and mounts |
| Installation type | Cutting or drilling required |
| Fitment | Direct fit |
Vehicle fitment
JcrOffroad lists these sliders for the 1984–2001 Jeep Cherokee (XJ), including the Base, Briarwood, Chief, Classic, Country, Laredo, Limited, Pioneer, SE and Sport trims, in both two-door and four-door bodies.
They fit 1984–2001 Jeep Cherokee (XJ) models only, in two-door and four-door bodies. Check year, model and trim against this fit before ordering.
Installation notes
Cutting or drilling is required, and the factory flares must be trimmed for a proper fit. Aftermarket Uniframe Stiffeners will not work without longer hardware. Rubicon Express long arm owners must remove the pinch seam gusset plates. If your long arm kit is not on the list, check the installation instructions to see whether the sliders work without modifications. Because the sliders depend on rocker strength, repair any structural damage to the Jeep before installing them.
What’s included
The sliders and their mounts together weigh approximately 90lbs.
Not included: Longer hardware for aftermarket Uniframe Stiffeners.
























