Overview
The G2 Toyota 8 inch third member, part number 7-2043-529L, is a complete third member assembly built on G2’s heavy duty V6 third member case, with a 5.29:1 gear ratio and a standard pinion. The units are new and assembled by experienced builders.
It has an Auburn limited slip differential. Confirm the differential type before ordering.
Key features
- Heavy duty V6 third member case
- 5.29:1 gear ratio with a standard pinion
- Listed with an Auburn limited slip differential
- Described by G2 as new and assembled by seasoned professionals
Setting up a gear set
A ring and pinion set is only as good as its setup. Backlash and pinion preload determine how the teeth mesh and how long the bearings last, and both must be measured rather than estimated. Shims control pinion depth, and a shop with the right gauges and a dial indicator can set these in one session.
After installation, the new gears need a break-in period in which loads are kept light and the lubricant is watched closely. Check for leaks and listen for whine during the first drives. Lubricant type and fill level matter for gear life, so use the fluid the gear set requires.
- Measure backlash at several points around the ring gear
- Confirm pinion preload before final assembly
- Change the lubricant after break-in if the service manual advises it
- Recheck torque on carrier bolts after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 7-2043-529L |
| UPC | 631410112078 |
| Third member make | Toyota |
| Housing | Heavy duty V6 third member case, Toyota 8 inch |
| Gear ratio | 5.29:1 |
| Pinion | Standard pinion |
| Differential | Auburn limited slip |
Vehicle fitment
This third member is an 8 inch Toyota unit. Compare the housing and axle to your own vehicle before installing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A gear set requires professional setup, including backlash and pinion preload, followed by a break-in period. Have a qualified shop install and set up the unit.
What’s included
It is a complete third member assembly with the gear ratio and differential shown above. Not included: Axle shafts, bolts and mounting hardware are not included.








