Overview
The G2 Axle and Gear 95-2021-001 is a rear replacement axle shaft for the GM 10 bolt 8.5 inch axle in 1980–1987 GM 1500 two-wheel-drive pickups. It has 28 splines and fits the driver or passenger side.
The alloy steel is forged and heat treated. The shaft is designed to handle the added load that bigger tires and more torque bring.
The 95-2021-001 is one of several GM 10 bolt 8.5 inch shafts, and its 28-spline count and two-wheel-drive use define it. It is forged alloy steel with heat treatment. It fits both Chevrolet and GMC trucks, so owners of either badge can use the same part number.
Key features
- Either driver or passenger side
- 28 splines
- GM 10 bolt 8.5 inch rear axle
- For 1980–1987 GM 1500 2WD
- Forged alloy steel with heat treatment.
- Wheel studs not included
Driveline checks for older half-tons
Two-wheel-drive half-ton trucks from this era often run with worn wheel bearings and rear seals, and a new axle shaft is a good moment to check both. The bearing sits between the shaft and the housing, so play in the hub or a grinding noise can point to a bearing rather than the shaft. Replacing the bearing and seal while the shaft is out saves a second job later.
Owners who fit larger tires should think about gearing, brakes and suspension travel as well, because each of them changes the load on the rear axle. A bigger tire increases stress on the shaft and the bearing. Keep the rear brakes in good order, since a worn brake can make the axle work harder on the way down a hill.
- Check bearing play before reusing the old hub
- Inspect the rear seal while the shaft is out
- Confirm brake condition when larger tires are fitted
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2021-001 |
| UPC | 631410106015 |
| Product type | Replacement axle shaft |
| Axle type | GM 10 Bolt 8.5 inch |
| Axle location | Rear |
| Shaft position | Driver Or Passenger |
| Spline count | 28 |
| Wheel studs | Not included |
| Stated application | 1980-1987 GM 1500 2 WD |
Vehicle fitment
It fits the 1980–1986 Chevrolet C10, 1987 Chevrolet R10, 1980–1986 GMC C1500 and 1987 GMC R1500.
All of these are two-wheel-drive trucks, and four-wheel-drive K-series trucks are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
- Wheel studs are not included, so they have to be supplied.
- Compare the 28-spline count with your differential gears.
What’s included
One rear axle shaft that fits either side (95-2021-001).
Not included: wheel studs for the 95-2021-001.










