Overview
The G2 Axle and Gear 2-2031-410 is a Dana 30 short front 4.10 ratio ring and pinion for the Jeep TJ Wrangler, WJ Grand Cherokee, XJ Cherokee and ZJ Grand Cherokee.
G2 says its ring and pinion sets are engineered with today’s demanding applications in mind, using computer heat treated 8620 steel, double shot peening, double lapping and O.E. specifications, plus a 10 year warranty. This front gear set is intended for a 3.73 and up carrier.
Key features
- Front Dana 30 short ring and pinion, 4.10 ratio
- For use in the front axle of 1997–2005 TJ Wrangler
- It also fits 1999–2005 WJ, 2000–2005 XJ and 1996.5–1998 ZJ front axles.
- Used with a 3.73 and up carrier
- Computer heat treated 8620 steel, double shot peened and double lapped
- Manufactured to O.E. specifications, with a 10 year warranty
Front axle gear choices
Short-case Dana 30 front axles are often upgraded for larger tires or a change in gearing. A 4.10 ratio gives more pulling force at low speed than a taller ratio, which helps with slow trail work, though highway cruising will run at a higher engine speed.
Front and rear gearing should be considered together, since mismatched ratios can strain the transfer case and driveline. Check tire diameter and transmission gearing before choosing, and match the carrier type to the set you buy. Keep the bolts snug and recheck them after early use.
Front differential service often includes pinion bearings, carrier bearings and new gear oil. Inspect the pinion yoke seal and the cover gasket while the front axle is open, and check tooth contact once the first drives are done.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2031-410 |
| UPC | 631410093858 |
| Product type | Front ring and pinion gear set |
| Gear ratio | 4.10 |
| Axle manufacturer | Dana |
| Axle type | Dana 30 TJ (short) |
| Axle location | Front |
| Carrier | For use with 3.73 and up carrier |
| Material | Computer heat treated 8620 steel |
| Manufacturing | Manufactured to O.E. specifications, double shot peened, double lapped |
| Warranty | 10 year warranty |
Vehicle fitment
It is for the front axle of the 1997–2005 Jeep TJ Wrangler, the 1999–2005 WJ Grand Cherokee, the 2000–2005 XJ Cherokee and the 1996.5–1998 ZJ Grand Cherokee.
This is a front axle gear set only, and it does not cover rear axles, the YJ Wrangler or other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
For the 2-2031-410, plan the front differential setup around the pinion depth, preload and backlash, using a 3.73 and up carrier. Because gear setup is exacting, a trained installer is the usual choice. Fresh gear oil is needed once the front differential is closed up again, and new gears need a careful break-in.
What’s included
- One front Dana 30 short ring and pinion gear set, 4.10 ratio
Not included: an installation kit, bearings, seals and carrier, which are separate parts.















