Overview
The G2 Axle and Gear 2-2013-488 is a 4.88 ratio ring and pinion for the Ford 8.8 inch rear axle. It fits the rear location and works with all ratio carriers, so the carrier does not limit the choice of 4.88 set.
G2 builds these gears for oversized tires and high performance engines. The set uses computer heat treated 8620 steel with double shot peened and double lapped surfaces, manufactured to O.E. specifications.
Key features
- 4.88 ratio rear ring and pinion
- Ford 8.8 inch rear axle
- Works with all ratio carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Final drive basics
A ring and pinion set is the final drive pair that multiplies engine torque to the axle shafts, and the gear ratio sets how the engine turns the tires at a given road speed. A numerically higher ratio such as this 4.88 gives more pulling force from a stop and more engine turns at highway speed, which helps with heavier tires and steep grades but raises engine speed and fuel use.
Because the pinion and ring gear are a matched pair, they are usually replaced together and set up at the same time. Pinion depth, backlash and bearing preload control how the teeth mesh and how long they last, so that setup is typically done by a driveline shop. A gear change also calls for new pinion and carrier bearings and a fresh pinion seal, which are commonly replaced in the same job.
- Check the axle housing and carrier before buying
- Replace the pinion bearings with the new set
- Note any tooth contact pattern or noise after the break-in run
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2013-488 |
| UPC | 631410093476 |
| Gear ratio | 4.88 |
| Axle location | Rear |
| Axle type | Ford 8.8 inch |
| Popular axle manufacturer | Ford |
| Carrier requirement | All ratio carriers |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
The 4.88 set is built for the Ford 8.8 inch housing. Confirm the housing size and your vehicle’s year, model and trim before ordering.
Only the Ford 8.8 inch is named for this 4.88 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A driveline shop should set pinion depth, backlash and bearing preload on the 8.8 inch 4.88 gears, then run the set through a break-in period.
What’s included
A matched ring and pinion for the Ford 8.8 inch rear axle.
















