Overview
The G2 Axle and Gear JK Metric CORE 44 rear axle with a 4.56 ratio and ARB Air Locker (part C4JMR456AP5) is for 2007 and newer Jeep Wrangler JK models. It uses a Dana 44 JK 8.8-inch gear design.
The housing is a new design built to handle loads that would normally bend a stock Dana 30 or Rubicon Dana 44. It is set up for lockers of the owner’s choice, and it is a direct fit that reuses the factory wheel ends and brakes.
Key features
- Dana 44 JK 8.8-inch gear design in a new housing
- Metric rear axle layout
- ARB Air Locker
- USA-made Placer Chromalloy axle shafts
- Designed to take aftermarket lockers
- Reuses factory wheel ends and brakes
Care for a locker axle
A rear axle with an air locker and a 4.56 gear set is more sensitive than a stock open axle. Engaging the locker on loose or slippery ground and releasing it on pavement keeps the mechanism working as intended.
Gear oil should be checked at routine service and changed when it looks dark, smells burnt or carries fine metal. Because the rear housing takes lockers of different types, a later swap should be planned with a shop that knows Dana 44 setups, since gear and locker work go together.
Cover the rear housing if the vehicle runs with a lift, because rock strikes can dent the cover and push seals out of position. Inspect the axle shafts and U-joints whenever the rear is serviced.
- Inspect the cover after rock strikes
- Change gear oil when it smells burnt
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4JMR456AP5 |
| UPC | 631410121032 |
| Position | Rear |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.56 |
| Traction device | ARB Air Locker |
| Axle spline | 35 splines |
| Axle shafts | Placer Chromalloy, 35 spline |
| Wheel bolt pattern | Reuse factory ends |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
This rear axle is built for the 2007–2018 Jeep Wrangler (JK) generation.
This axle is designed for the JK, so check your year, model and trim before buying, particularly for TJ, LJ or JL Wranglers.
Installation notes
The factory wheel ends and brakes are reused. A 4.56 gear set with a locker calls for professional setup and break-in, and the axle should be set up by a shop that works on Dana 44 rears.
What’s included
The complete rear axle assembly with the 4.56 gear set and ARB Air Locker.

















