Overview
The Dana Spicer D/S10128137 is an Ultimate Dana 60 rear crate axle assembly with a 5.38 gear ratio and an Eaton E-Locker, built for the Jeep Gladiator JT. It is a direct fit for the 2020–2026 Jeep Gladiator.
This is a complete rear axle assembly supplied as a crate unit, so the housing, gears and locker arrive together. The Ultimate Dana 60 rear suits off-road use over rocks, across sand and through mud, where axle upgrades are common.
Key features
- Ultimate Dana 60 rear crate axle assembly
- 5.38 gear ratio
- Eaton E-Locker traction device
- Direct fit for the Jeep Gladiator
Before installing a crate axle
Swapping in a complete rear axle is a larger job than a bolt-on accessory, so plan the work around the whole assembly. A crate unit arrives built, which shortens the setup time, but the truck still needs its driveshaft, brake lines and suspension mounts checked against the new housing before it returns to the road. A 5.38 ratio changes low-speed feel and engine speed at highway pace, so tire size and transmission setup should be considered together.
An Eaton E-Locker engages fully, so new drivers should learn how it behaves on pavement before relying on it in rough terrain. Lockers change how a truck turns at low speed, and they are often paired with a gear oil check and a bearing inspection after the first trail outings.
- Check driveshaft length and yoke fit
- Confirm brake line routing before the first drive
- Re-check axle bolts after the first few trail runs
- Refresh gear oil on an interval suited to your use
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | D/S10128137 |
| Axle type | Ultimate Dana 60 rear crate axle assembly |
| Position | Rear |
| Gear ratio | 5.38 |
| Traction device | Eaton E-Locker |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2020–2026 Jeep Gladiator JT body. It fits Gladiator model years 2020 through 2026 only.
It is made for the Jeep Gladiator only, so match your vehicle’s year, model and trim before ordering.
What’s included
The complete rear crate axle assembly with the Eaton E-Locker and 5.38 gears. Check the package contents against your installation before starting.










