Overview
The Dana Spicer 10032864 is an Ultimate Dana 44 front axle assembly with a 4.88 gear ratio, built for the Jeep Wrangler JK. It is a direct fit for the 2007–2018 Jeep Wrangler (JK) in 2-door and 4-door models, and it bolts in as a complete front axle.
Dana Spicer presents this axle as an upgraded Dana 44 for owners who drive their JK hard off-road. Its upgrades include Spicer nickel chromoly steel axle shafts, a Spicer performance differential cover and SPL 1350 axle shaft universal joints, all of which the company says add on-trail durability and strength over the stock front axle.
The axle uses an open differential with 30 spline shafts. The brakes are reused from the vehicle, and the wheel bolt pattern is 5 on 5 inches. The axle requires the stock wheel ends to be reused, so the hubs and wheel ends from the original axle carry over.
Key features
- Dana 44 front housing for the Jeep Wrangler JK
- 4.88 gear ratio
- Open differential
- Spicer nickel chromoly steel axle shafts with 30 splines
- Spicer performance differential cover
- SPL 1350 axle shaft universal joints
- 5 on 5 inch wheel bolt pattern, with reused stock brakes
Upgrading a JK front end
A front axle swap changes more than the housing. The gear ratio, tire diameter and speedometer calibration all work together, so a change to one can alter how the vehicle drives and reads speed. Owners who run larger tires often pair a new ratio with recalibration, and they check the steering linkage and driveline angles at the same time.
Because the hubs, brakes and wheel bearing hardware carry over from the original axle, inspect them for wear before installing the new housing. Check the wheel bolt pattern and the spline fit of the hubs carefully. Driveline angles and steering geometry can shift after a front axle swap, so plan an alignment check once the job is complete.
- Inspect the reused hubs and wheel bearings
- Recalibrate the speedometer after a tire change
- Re-check driveline angles after the swap
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | D/S10032864 |
| Axle type | Ultimate Dana 44 front |
| Position | Front |
| Housing | Jeep JK, Dana 44 (2007 onward) |
| Gear ratio | 4.88 |
| Axle spline | 30 splines |
| Traction device | Open differential |
| Wheel bolt pattern | 5 on 5 inches |
| Brakes | Reuse factory |
| Axle shafts | Spicer nickel chromoly steel |
| U-joints | SPL 1350 |
| Differential cover | Spicer performance |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK), in 2-door and 4-door versions. The fit runs 2007 to 2018, the last year of the JK body.
Its fit is the Wrangler JK only. The 2018–2022 Jeep Wrangler (JL) and the Gladiator use a different front axle, so the JK fit does not carry over to them.
Installation notes
Because the axle is a direct bolt-in, the stock wheel ends, brakes and wheel bearing hardware from the original front axle must be moved to this housing. Check the wheel bolt pattern and the 30 spline shafts against the hubs you plan to reuse.
What’s included
The assembly includes the Dana 44 front housing, Spicer nickel chromoly axle shafts, the Spicer performance differential cover and SPL 1350 axle shaft universal joints.
Not included: the stock wheel ends, which the axle requires you to reuse.










