Overview
The G2 Axle and Gear CORE 44 rear axle assembly with a 4.88 ratio and Detroit True Trac locker (part C4TSR488TC0) fits 1997–2006 Jeep Wrangler TJ and LJ models. The housing is a high pinion Dana 44 gear design, and it is a direct fit that reuses the factory brakes.
The housing is a whole new design built to handle loads that would normally bend a stock Dana 30 or Rubicon Dana 44. It takes stock Dana 44 ring and pinions and axle shafts, and it accepts aftermarket lockers.
Key features
- High pinion Dana 44 gear design in a new housing
- Detroit True Trac locker
- Designed to handle heavy loads
- Accepts stock Dana 44 ring and pinions, axle shafts and aftermarket lockers
- 30-spline axle spline
- Reuses factory brakes
Rebuilding a Dana 44 housing
A Dana 44 housing is often rebuilt around the ring and pinion set, bearings and seals. Because this housing takes stock Dana 44 ring and pinions, owners can keep their existing gears when the rear is assembled, provided the parts are in good condition.
Before reuse, check the ring and pinion teeth for pitting or chipping, and look at the bearings for roughness. A Detroit True Trac locker changes the feel of the axle, so a shop familiar with Dana 44 builds should set the gear pattern and preload.
Keep the axle shafts and hub bolts in good order, since worn splines can make the axle clunk under load. Replace seals during any rebuild to avoid fluid loss, and check the cover bolts for tightness at each service.
- Inspect ring and pinion teeth for pitting
- Replace seals during a rebuild
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4TSR488TC0 |
| UPC | 631410133691 |
| Position | Rear |
| Housing type | 97-06 Jeep TJ Dana 44 |
| Gear ratio | 4.88 |
| Traction device | Detroit True Trac |
| Axle spline | 30 splines |
| Wheel bolt pattern | 5 on 4.5 inches |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
It fits 1997–2006 Jeep Wrangler TJ and LJ models.
JK and YJ Wranglers are not covered, so check your year, model and trim before buying.
Installation notes
Gears and a Detroit True Trac locker on a Dana 44 need professional setup and break-in. The 30-spline shafts and 5 on 4.5 inch pattern should be checked against the hubs and wheels in use.
What’s included
The complete rear axle assembly with the 4.88 gear set and Detroit True Trac locker.














