Overview
The Artec Industries TJ3022 is the JK2TJ front axle swap kit, a heavy duty truss and bracket system for a Dana 30 front axle. It is for 1997 to 2006 Jeep Wrangler TJ models and 2004 to 2006 Wrangler LJ Unlimited models, and it reinforces the entire axle.
The 1/4 inch thick truss top has link brackets built in, so the factory link, anti-sway bar, tracbar and shock locations come with the truss. Place the truss on the axle, and the other brackets fit into position exactly where they need to be.
Key features
- 1/4 inch thick truss top that reinforces the axle and carries the link brackets
- Factory link, anti-sway bar, tracbar and shock locations built into the bracket system
- Link mounts built into the truss, which Artec says avoids hours of trial and error compared with other bracket systems
- Built for Dana 30 front axles
Fitment and welding checks
A front swap is a fit-first job. Place the truss on the Dana 30 axle, then confirm each bracket lines up with the factory link, anti-sway bar, tracbar and shock locations. Make small adjustments before any final welding, since the brackets are only as accurate as their placement.
Steering setup needs attention with a front axle swap. A steering ram mount is not part of this kit, so plan that component separately if your build calls for one. Check the tie rod and drag link geometry once the axle is installed and confirm the wheel travel is not limited by the new parts.
Routine inspection matters after the swap. Check the link brackets, shock mounts and tracbar attachments for cracks or loose hardware after rough trail use. Retighten fasteners on the first few drives, and recheck alignment before the vehicle sees regular road use.
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | A/ITJ3022 |
| Axle type | Dana 30 |
| Axle location | Front |
| Steering ram mount | Without steering ram mount |
| Truss top thickness | 1/4 inch |
Vehicle fitment
Fits 1997 to 2006 Jeep Wrangler TJ models, including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims. It also fits 2004 to 2006 Wrangler LJ Unlimited and Unlimited Rubicon models.
Wrangler YJ, JK, JL and JT models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Place the truss on the Dana 30 axle and confirm the brackets sit at the factory link, anti-sway bar, tracbar and shock locations before final welding or fastening. Have a qualified welder complete any welding on the axle.
What’s included
One JK2TJ front axle swap kit, consisting of a truss and bracket system with link brackets for the factory link, anti-sway bar, tracbar and shock locations.
Not included: a steering ram mount, since this kit is listed without one.












