Overview
The Artec Industries TJ6063 is a TJ 1 ton front Dana 60 swap kit for the 1997–2006 Jeep Wrangler (TJ). It is a truss and bracket system for front 60 axles that adds a single adjustable upper link mount for a 3-link setup, built from 3/8 inch and 1/4 inch mild steel truss with 3/16 inch coil brackets.
The link brackets are jigged into the truss, so the lower control arm, shock and anti-sway bar brackets line up without measuring. The 1/4 inch interlocked gussets add strength, and the upper link mount can be adjusted for later link geometry changes.
Key features
- Adjustable single upper link mount for 3-link arm setups
- 3/8 inch and 1/4 inch mild steel truss for higher strength than the factory bracket
- 3/16 inch coil brackets
- Brackets jigged into the truss for automatic positioning
- 1/4 inch interlocked gussets for maximum truss strength and easier assembly
- Low-profile design that is less likely to interfere with vehicle components
- Brackets for upper and lower control arms, shock mounts, anti-sway bar mounts, track bar mount and coil spring mounts
Adjusting the upper link
The upper link angle affects how the axle moves under braking and acceleration, and it also changes how the axle rotates through its travel. A single adjustable upper link mount gives room to set that angle once the axle and springs are in place, instead of locking it in at the start. Set the axle at its normal ride height before finalizing the link position.
Front axle swaps are heavy work, so plan the sequence carefully. Dry fit the truss, check the coil brackets and link joints, and confirm brake line routing before any final welding. After the first trail outings, recheck the link angle and mount welds, and look for any movement at the brackets.
- Set ride height before finalizing link angle
- Confirm brake line routing before welding
- Recheck mounts after early trail use
Specifications
| Brand | Artec Industries |
|---|---|
| Part number | TJ6063 |
| UPC | 816791026446 |
| Axle type | Dana 60 |
| Axle location | Front axle |
| Upper link mount | Adjustable, single, for 3-link |
| Truss thickness | 3/8 inch and 1/4 inch mild steel |
| Coil bracket thickness | 3/16 inch |
| Gusset thickness | 1/4 inch, interlocked |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1997-2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims. It is a front Dana 60 axle kit.
It is not made for the 2007-2018 Wrangler JK, the 2018-2022 Wrangler JL or the Gladiator JT, and it is not for rear axles. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires general welding, some grinding and relocating the brake lines. Tack weld the truss together, set it on the axle, and check that the brackets seat correctly before final welding. Some fitment grinding may be needed, so weld in a clean, well-ventilated area away from fuel and brake components.
What’s included
The kit includes the truss and all brackets needed for a complete front axle swap: upper and lower control arm mounts, shock mounts, anti-sway bar mounts, track bar mount and coil spring mounts.
Not included: the Dana 60 axle, control arms, coil springs and shock absorbers, which must be sourced separately.









