Overview
The Advance Adapters V6 manual transmission to GM V8 adapter bellhousing kit, part 712561, is the bellhousing assembly for adapting a GM 4.3 or 350 V8 to a 1986-95 Toyota Truck five-speed manual transmission. The transmissions are identified as R150F and R151F.
The five-speeds were used in 4 cylinder turbo trucks and 3.0 V6 trucks, so the kit description is written around that transmission swap rather than those engines.
Key features
- 356 T-6 aluminum bellhousing
- Universal dust cover plate
- Pilot bushing and throw-out arm for the clutch
- Slave cylinder push rod, push rod end and ball pivot
- Fastening hardware and adapter instructions included
Before you buy
A bellhousing swap changes how the engine, clutch and transmission line up, so check each connection before committing to the project. Measure the space behind the engine and confirm the transmission input shaft clears the bellhousing face before final bolt-up. Small misalignment often shows up later as clutch chatter, a noisy release or premature bearing wear.
Clutch parts are usually replaced together during a conversion like this. A worn disc, pressure plate or release bearing is far easier to address while the transmission is out. Look at the slave cylinder seal and push rod for leaks or play, and replace anything cracked, stiff or bent before the truck goes back on the road.
- Check the throw-out arm pivots freely
- Inspect the flywheel face for scoring
- Confirm driveshaft length after the swap
Specifications
| Brand | Advance Adapters |
|---|---|
| Part number | 712561 |
| UPC | 70000002175 |
| Bellhousing material | 356 T-6 aluminum |
| Engines | GM 4.3 and 350 V8 |
| Transmissions | R150F and R151F, 5 speed manual |
| Application | 1986-95 Toyota Truck |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. Check that your truck has an R150F or R151F five-speed manual transmission.
This kit is for a GM 4.3 or 350 V8 and does not cover the 4 cylinder turbo or 3.0 V6 truck engines. Confirm your engine before ordering.
Installation notes
Setup involves the throw-out arm, slave cylinder push rod and ball pivot included in the kit. Follow the adapter instructions packed with the kit for these parts.
What’s included
The kit includes the 356 T-6 aluminum bellhousing, universal dust cover plate, pilot bushing, throw-out arm, slave cylinder push rod, slave cylinder push rod end, ball pivot, fastening hardware and adapter instructions.
Not included: the engine, transmission and clutch components, which the adapter has to connect.









