Overview
The Rubicon Express RE4400 is a rear Tri-Link truss kit for the 1997 to 2002 Jeep Wrangler (TJ). It converts a rear long arm system to a true 3-link setup and removes the rear track bar.
The track bar can cause lateral axle movement, which the Tri-Link setup is designed to control. This kit suits owners who already run a Rubicon Express long arm system and want to triangulate the rear of the TJ. Exhaust modifications are required, and shocks are sold separately.
Key features
- Tri-Link conversion for the rear suspension
- Eliminates the rear track bar
- HD SF1 pivot ball assembly
- 5/8-inch grade 8 hardware
- Up to 32 degrees of misalignment at the pivot ball
- Hardware and instructions included
Before you install
A rear track bar locates the axle side to side, and a Tri-Link arrangement takes over that job by holding the axle in place with angled control links. On a TJ with a long arm system, the change affects how the axle moves through articulation and how the body responds under braking and when cornering on loose surfaces. Triangulated links handle lateral loads differently from a single bar, so the setup is best judged as a whole system rather than as one part.
Because the truss replaces the track bar, the rest of the rear suspension is usually reviewed at the same time. Bushings, the pivot ball joints and the frame mounts all see new loads, and worn parts are worth inspecting before the kit goes on. Shock choice matters as well, since the mounting points and travel of the rear shocks should match the long arm and truss geometry.
- Inspect rear bushings and mounts before install
- Check the axle housing for tight clearance at full articulation
- Recheck pivot ball bolts after the first few trail runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE4400 |
| UPC | 614901441284 |
| Kit type | Rear Tri-Link truss kit |
| Pivot | HD SF1 pivot ball assembly |
| Hardware | 5/8-inch grade 8 |
| Misalignment | Up to 32 degrees |
| Fitment | Direct fit |
Vehicle fitment
The kit is a direct fit for the 1997 to 2002 Jeep Wrangler (TJ). It is built around the rear of the TJ and is not intended for other generations.
The stated years are 1997 to 2002, so models outside that range are not the covered application. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Exhaust modifications are required for installation, so plan for that work before the truss is mounted. The 5/8-inch grade 8 hardware and instructions are included.
What’s included
The kit includes the HD SF1 pivot ball assembly, the 5/8-inch grade 8 hardware and instructions.
Not included: Shocks.












