Overview
The Rubicon Express RE1136 is a pair of extreme-duty front sway bar disconnects for the 2018 to 2026 Jeep Wrangler JL and the 2020 to 2026 Jeep Gladiator JT. They let the front sway bar be disconnected for more front axle articulation.
The threaded body adjusts for different lift heights and for the sway bar angle. It covers 2.5 to 6 inch lifts and also works with stock suspension.
Key features
- Disconnects the front sway bar for increased front axle articulation
- Heavy duty threaded body adjusts for lift height and sway bar angle
- Zinc-plated snap pin for quick disconnect
- Tapered post and spherical bushing make reconnecting easier on uneven ground
- Pre-installed grease fittings with greasable bushings
- Silver powder coat finish
- Heavy-duty steel construction for high strength and long life
Before you buy
A front sway bar links the left and right sides of the axle so the body resists roll on pavement. Disconnecting it lets each front wheel move more independently over uneven ground, which is why off-road builders use disconnects when they need more wheel travel. The trade-off is that the vehicle leans more in corners and on highway driving, so most owners reconnect the bar for daily use.
Before buying, match the disconnect to your lift height and the angle of your sway bar links. A higher body changes the geometry, and the adjustable threaded body helps set the correct length. Check the sway bar links, bushings and mounting hardware for wear at the same time, since worn parts can rattle or loosen after repeated disconnecting and reconnecting.
Grease the bushings on a regular schedule, especially after mud or water crossings, and inspect the snap pin for bends or corrosion. A bent pin can make reconnecting difficult on the trail.
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | R/ERE1136 |
| Position | Front |
| Type | Greasable |
| Lift range | 2.5 to 6 in |
| Finish | Silver powder coat |
| Pin | Zinc-plated snap pin |
Vehicle fitment
It fits the 2018 to 2026 Jeep Wrangler JL in two-door and four-door models, and the 2020 to 2026 Jeep Gladiator JT.
It does not fit the Wrangler JK or earlier generations. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Installation is a bolt-on job. Whether the sway bar must be unbolted or drilled depends on the setup, so follow the included instructions before starting.
What’s included
The front sway bar disconnects under part number R/ERE1136.











