Overview
The Rubicon Express RE1130 is an extreme-duty front sway bar disconnect that lets the front sway bar be unhooked for more front axle articulation. It works with stock and lifted suspensions. The threaded body is adjustable for different lift heights and for setting the sway bar angle, and it bolts on easily.
A zinc plated snap pin is pulled to disconnect the bar. The tapered post and spherical bushing make reconnection straightforward on irregular terrain, and no tools are needed for that step. Confirm the vehicle before buying, since sway bar disconnects are sized for specific axles and setups.
Key features
- Adjustable length design for different lift heights
- Heavy duty threaded body
- Spherical bushing
- Tapered post for easy reconnection
- Zinc plated snap pin for quick disconnect
- Pre-installed grease fittings
- Silver powder coat finish
- Easy bolt-on installation
- Made in the USA
Sway bar disconnects off road
A front sway bar limits body roll on the road, but it also restricts how far one front wheel can rise over an obstacle. A disconnect lets the bar be unhooked so the axle can articulate more freely on rough ground. The trade-off is that body roll increases while the bar is disconnected, so it is usually reconnected before highway driving.
Pin and bushing care matter because the disconnect is used repeatedly. Grease the spherical bushing and keep the snap pin clean so it stays easy to release. Dirt and water in the bushing can make the disconnect harder to pull and can cause squeaks or wear.
Choosing the right setup comes down to lift height and sway bar angle. A disconnect adjusted for the lift keeps the link from bottoming out or pulling the axle out of alignment. After changing the length, check the bar angle and clearance through full suspension travel.
- Grease the bushing after each trail trip
- Keep the snap pin clean and free
- Recheck bar angle after changing lift
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1130 |
| UPC | 614901091175 |
| Position | Front |
| Length | Adjustable |
| Bushings | Spherical, greasable |
| Finish | Silver powder coat |
| Fitment type | Direct fit (vehicles not named) |
Vehicle fitment
Confirm your vehicle’s year, make, model and trim before ordering so the disconnect matches your axle and sway bar setup.
Sway bar disconnects are sized for specific axles and sway bar setups, so confirm the vehicle before buying. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The disconnect bolts on in place of the sway bar link. Set the threaded length for your lift height and the sway bar angle, and grease the fittings after installation to keep the bushings quiet and working.
What’s included
The adjustable sway bar disconnect with its spherical bushing, snap pin and grease fittings is included. Check the parts list for any hardware before starting the install.





