Overview
The Rubicon Express RE3700 is a pair of front fixed lower Super-Flex control arms, driver and passenger side, for the TJ, LJ, XJ, MJ and ZJ Jeep chassis.
The arms fit TJ Wranglers and the front lower positions on XJ, MJ and ZJ chassis. They are for the front only, so the rear control arm positions are not covered.
Each arm uses a rebuildable spherical bearing: a 2.25-inch polymer race encapsulates a 1.75-inch hard plated steel bearing. A threaded steel insert allows adjustable preload, and the joint is greasable.
The non-metallic races keep the joint quiet. The bearing is designed to allow extra flex for off-road use while keeping on-road handling in mind.
Key features
- Driver and passenger side arms, sold as a pair
- Fixed-length tubular arms
- Rebuildable spherical bearing
- 2.25-inch polymer race around a 1.75-inch hard plated steel bearing
- Threaded steel insert for adjustable preload
- Greasable joint with non-metallic races
Greasing and bearing care
A spherical bearing in a control arm carries load while letting the arm pivot in several directions. Polymer races help keep the joint quiet, but they still wear, so check the bearing during routine service. Preload set on the threaded insert changes how tight the joint feels, so adjust it in small steps and recheck after the first drives.
Because the bearing is rebuildable, a worn joint can often be serviced instead of replaced. Keep the grease fitting clean and use a grease suited to the joint. Inspect the seal and boot for cracks, since dirt and water shorten bearing life on any trail vehicle. Keep spare grease on hand for trail trips.
- Grease the joint before each trail season
- Recheck preload after the first drives
- Inspect seals and boots for cracks
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE3700 |
| UPC | 614901440461 |
| Position | Front lower |
| Sold as | Pair |
| Length | Fixed |
| Race | 2.25-inch polymer |
| Bearing | 1.75-inch hard plated steel |
| Adjustment | Threaded steel insert |
| Maintenance | Greasable and rebuildable |
Vehicle fitment
It fits the Wrangler TJ (1997–2006) and LJ (2004–2006), the Cherokee XJ (1984–2001), the Comanche MJ (1986–1992) and the Grand Cherokee ZJ (1993–1998). Each arm fits the front lower position only.
The rear control arm positions are not covered, and the chassis list does not include the Wrangler JK, JL or YJ, or the Grand Cherokee WJ. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the preload with the threaded insert and grease the joint during installation, since both are part of the design. The bearing is rebuildable, so it can be serviced later rather than replaced.
What’s included
A pair of front lower control arms, driver and passenger side.







