Overview
The Rock Krawler RKSRK06190B is a rear lower control arm from the X Factor line, built for the 2018–2026 Jeep Wrangler (JL) and the 2020–2026 Jeep Gladiator (JT). It is made from 1.75 inch OD solid alloy steel with a black powder coat and is bent for ground clearance off-road.
The axle end uses a Pro Series Krawler joint, and the frame end uses an Adventure Series joint with service-free Garlock bearings and a nitride coated pivot sleeve. Rock Krawler gives the arm a total misalignment capability of 95 degrees. The figures are the joint ratings the company publishes, so they show how far each joint can articulate before the arm reaches its limit.
Key features
- 1.75 inch OD solid alloy steel
- Bent for improved ground clearance
- Pro Series Krawler joint at the axle, serviceable and rebuildable
- Adventure Series frame joint with OEM style vulcanized rubber
- Service-free Garlock bearings and a nitride coated pivot sleeve
- 95 degrees total misalignment
Axle location and driveline effects
A rear lower control arm works with the rest of the rear axle to hold its position under acceleration, braking and articulation. The arm carries load through its frame and axle mounts, so any change in its angle shifts pinion angle and driveline geometry. That is why worn bushings or joints beside the arm are often replaced at the same time.
Joints at each end take most of the articulation. Check the axle-end joint for play and rebuild condition, and look at the frame-end bushing for cracking or separation. Worn joints can knock or let the axle wander on uneven ground, and the arm should be replaced once the joint can no longer be serviced.
After installation, drive at low speed and listen for clunks when throttle changes direction. Recheck the mounting hardware after the first few trail runs, since bolts can settle under repeated flex.
- Look for play at both joints before each trail season
- Note any new vibration at highway speed
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK06190B |
| Position | Rear lower |
| Tube | 1.75 inch OD solid alloy steel |
| Finish | Black powder coat |
| Axle joint | Pro Series Krawler joint, 60 degrees misalignment |
| Frame joint | Adventure Series joint, 35 degrees misalignment |
| Total misalignment | 95 degrees |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler (JL), in 2-door and Unlimited 4-door bodies, and the 2020–2026 Jeep Gladiator (JT).
It is built for the JL and JT. Match your Jeep’s year, model and trim against the fit above before ordering.
Installation notes
A rear lower arm sets the axle location and pinion angle, so check the driveline angles after installation.
What’s included
One rear lower control arm.









