Overview
The Rock Krawler RKSRK06184B is a front lower control arm from the X Factor line for the Jeep Wrangler JL and Gladiator JT. It is made from 1.75 inch OD, 0.313 inch wall DOM steel and bent to improve ground clearance for off-road use.
The arm is adjustable and combines a Pro-Krawler joint at the frame with a Pro-Flex joint on the frame side connection. The design is built for off-road articulation and adjustment.
Key features
- 1.75 inch OD, 0.313 inch wall DOM steel
- Black powder coat finish
- Bent for improved ground clearance
- Adjustable 1.25 inch shank Pro-Krawler joint at the frame, rebuildable and serviceable
- Pro-Flex joint with 70a durometer thermoelastomer raceways for vibration isolation
- Total misalignment capability of 90 degrees
Adjustable arm setup
An adjustable control arm lets you set the length so the axle and wheel geometry can be brought back toward the correct position after a lift. Changing the length is the easy part; the real work is confirming the arm is set evenly on both sides and that the joints have room to move through their full travel. Uneven settings can pull the vehicle or wear tires unevenly, so take time with each adjustment.
A rebuildable frame joint is a practical feature for trail use. Inspect the joint for play, keep it greased, and replace the boot if it is torn so grit does not reach the bearing. The thermoelastomer raceways in the Pro-Flex joint are meant to isolate vibration, so check them for cracking or flattening during routine inspections.
- Lock jam nuts fully after each length change
- Re-check the joints after the first few trail runs
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RKSRK06184B |
| Position | Front lower |
| Tube | 1.75 inch OD, 0.313 inch wall DOM steel |
| Finish | Black powder coat |
| Frame joint | Adjustable 1.25 inch shank Pro-Krawler joint, 60 degrees misalignment, serviceable and rebuildable |
| Pro-Flex joint | 70a durometer thermoelastomer raceways, 30 degrees misalignment |
| Total misalignment | 90 degrees |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler (JL) in 2-door and Unlimited 4-door bodies across the Sport, Rubicon, Sahara, Moab and Willys models, and the 2020–2026 Jeep Gladiator (JT).
It is intended for the JL Wrangler and JT Gladiator, so the JK, TJ, LJ Wrangler and Cherokee fall outside its fit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Adjustable arms change caster and the alignment, so have the front end aligned after the length is set.
What’s included
One front lower control arm.









