Overview
The Alloy USA front 27 spline outer axle shaft, part 10104, is a driver or passenger side outer stub with 27 splines and a 6.11 inch overall length. It is made to fit 1987–1995 Jeep Wrangler YJ and 1997–2006 Jeep Wrangler TJ models.
The shaft is made from 1541H or 4140 steel, depending on the application. It is heat treated and induction hardened, and it accepts a 5-760X U-joint. It fits Dana 30 reverse, Dana 30 TJ and Dana 44 front axles.
Key features
- Front outer stub shaft with 27 splines
- Works on driver or passenger side
- 6.11 inch overall length
- Built for a 5-760X U-joint
- 1541H or 4140 steel, heat treated and induction hardened
- The shaft is up to 35% stronger than a stock shaft.
Matching the shaft to your axle
An outer stub takes the full load of the wheel, so the shaft and its splines need to match the axle and hub exactly. Before you buy, count the splines on the stub you are removing, measure its length, and confirm the axle type. A mismatch in spline count will not seat correctly, and a short shaft can leave the U-joint out of position.
The U-joint, axle seals and bearings are often replaced at the same time as the shaft, since they are reached through the same job. Check the U-joint yokes for wear, and grease the joint before assembly. Worn outer stubs often show grooves in the splines or play at the hub, which means the shaft should be replaced.
- Clean spline surfaces before installing
- Check hub nut torque after the first drives
- Inspect the axle seal for leaks when the shaft is removed
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 10104 |
| UPC | 70000338951 |
| Axle types | Dana 30 reverse, Dana 30 TJ, Dana 44 |
| Axle location | Front |
| Shaft location | Outer stub |
| Side | Driver or passenger |
| Spline count | 27 splines |
| Overall length | 6.11 inches |
| U-joint | 5-760X |
| Material | 1541H or 4140 steel, depending on application |
| Treatment | Heat treated and induction hardened |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) and 1997–2006 Jeep Wrangler (TJ).
Wrangler JK and LJ models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the outer stub you are replacing and check its 27 spline count and 6.11 inch length against this shaft before you start the job.
What’s included
One outer axle shaft.
Not included: U-joint.









