Overview
The G2 Axle and Gear 95-2049-2-301 is a Dana 35 replacement axle shaft for the passenger side, made for C-clip axles with the 30 spline upgrade. It fits the Jeep Cherokee XJ, Wrangler TJ and Wrangler YJ.
G2 words its range as 90-06 YJ, XJ and TJ. The company says its shafts are forged from high grade alloy steel and heat treated to exceed OEM specifications.
The 95-2049-2-301 is a passenger-side Dana 35 shaft for C-clip axles, offering 30 splines as an upgrade. It fits three Jeep lines from 1990 to 2006. Shafts of this type are forged from high-grade alloy steel and heat treated beyond OEM specifications.
Key features
- Dana 35 rear axle
- 30-spline upgrade
- Passenger-side shaft
- For C-clip axles
- Heat treated beyond OEM specifications.
Before you buy
A rear axle shaft carries engine torque from the differential out to the wheel, and on a Dana 35 C-clip axle the spline count has to match the gears inside the carrier. Before ordering, confirm the gear spline count in your differential, because a 30-spline shaft will not seat in a 27-spline carrier. Trucks run on rough trails or with heavier tires put more twist through the shaft, so the upgrade matters most in those setups.
Wear usually shows at the splines and the bearing seat. Inspect for twisted or chipped splines, grease leaking from the axle tube, and clunking when the vehicle moves off from a stop. A worn C-clip retainer and the axle seal should be checked during the same job, since both are removed when the shaft comes out.
- Match the gear spline count before buying
- Check the C-clip and retainer for wear
- Replace the axle seal during the same job
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 95-2049-2-301 |
| UPC | 631410096828 |
| Product type | Replacement axle shaft |
| Axle type | Dana 35 |
| Axle location | Rear |
| Shaft position | Passenger Side |
| Spline count | 30 |
| Stated application | 90-06 Jeep YJ/XJ/TJ (C-Clip) w/30 Spline Upgrade |
Vehicle fitment
It fits the 1990–2001 Jeep Cherokee (XJ), the 1997–2006 Jeep Wrangler (TJ) and the 1990–1995 Jeep Wrangler (YJ).
The Cherokee fits through 2001, the YJ through 1995 and the TJ through 2006. Later Wrangler JK and LJ models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
- The axle must be C-clip, and the differential gears must be 30-spline.
What’s included
One passenger-side Dana 35 axle shaft (95-2049-2-301).
Not included: the gears and wheel studs for the 95-2049-2-301.







