Overview
The Omix-ADA 16530.08 is a Dana 44 rear axle shaft for Jeep CJ models, fitted to the 1970–1975 CJ5 and the 1986 CJ7. It is sold as the passenger side shaft.
It is a direct OE replacement built to the original Jeep specifications. The shaft has a 30-spline end and comes with axle studs. It carries a limited five-year warranty.
Key features
- Direct OE replacement for Dana 44 rear axles
- 30-spline shaft end
- Includes axle studs
- Built to original Jeep specifications
- Covered by a limited five-year warranty
Installing a rear axle shaft
A rear axle shaft transmits power from the differential to the wheel hub, so its spline end and flange need to match the axle exactly. Before removing the old shaft, note the side it came from and count the splines on the end, since shafts for the two sides are often different parts. Clean the bore and the hub flange, and check the axle studs for thread damage.
Shafts commonly fail at the spline end or at the flange where the stud holes take load, so look for cracking, twisting or uneven wear on the old part. Replacing the axle studs at the same time, and checking the bearing and seal at the axle end, saves a second teardown. Wheel bearing grease and the axle end seal are often the next items to check while the hub is open. Torque the flange nuts evenly and recheck them after a short drive.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16530.08 |
| UPC | 804314041199 |
| Axle type | Dana 44 |
| Axle location | Rear |
| Shaft position | Driver or passenger side (rear left) |
| Spline count | 30 splines |
| Included | Axle studs |
| Warranty | Limited five-year warranty |
Vehicle fitment
The shaft fits 1970–1975 Jeep CJ5 models and the 1986 Jeep CJ7 with a Dana 44 rear. It covers CJ5 base and Renegade trims, and CJ7 base, Laredo and Renegade trims.
The title names the passenger side, and the side should be confirmed against your axle. Confirm your year, model and trim before ordering.
What’s included
One Dana 44 rear axle shaft with axle studs.
