Overview
The Omix-Ada axle shaft bearing retainer ring, part number 16560.38, is a bearing retainer ring for Dana 35/44 axle shafts. It is a direct OE replacement built to original specifications, and it carries a limited five year warranty.
Axle bearing retainers
The bearing retainer ring holds the axle shaft bearing in its bore and keeps it from moving under load. When it cracks, deforms or wears at its seat, the bearing can shift, which causes noise, vibration and eventually bearing damage. Retainers are often replaced whenever the axle shaft bearing or seal is serviced.
Before fitting a new ring, clean the bearing bore and check the sealing surfaces for scoring. Make sure the ring seats fully and that the bearing is correctly placed. Replacing the bearing and seal at the same time is a sensible habit, since they wear together and a single old component can cause a repeat job.
- Clean the bearing bore before fitting
- Check the seat for cracks or deformation
- Replace the bearing and seal together when practical
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16560.38 |
| UPC | 70000021203 |
| Axle family | Dana 35/44 |
| Warranty | Limited five year warranty |
Vehicle fitment
Omix-Ada gives direct fit as the only fitment note, with no vehicle years, makes or models. Dana 35 and Dana 44 are axle designations rather than vehicle names, so check the specifications for your axle and model before ordering.
Confirm your vehicle’s year, model and trim before ordering.









