Overview
The Omix-Ada 16536.05 is a rear Dana 44 axle wheel bearing. Omix-Ada says one is required per axle, so check how many your rear end needs before ordering.
It fits the 1970-1975 Jeep CJ5, the 1986 CJ7, the 1993-1998 Grand Cherokee (ZJ), the 2004-2006 Wrangler (LJ), the 1997-2001 and 2003-2006 Wrangler (TJ) and the 2007-2011 Wrangler (JK).
Key features
- Rear Dana 44 position
- One required per axle
- Direct OE replacement built to original specifications
- Limited five-year warranty from Omix-Ada
Bearing wear and replacement
A rear wheel bearing carries the weight of the vehicle and the forces of cornering, so wear shows up as noise and play before it fails. Growling that changes with speed, looseness when the wheel is rocked, and heat at the hub are the usual signs. Inspect the hub seal at the same time.
Bearings are often replaced in pairs on the same axle so the wear stays even. Clean the hub and spindle surfaces, use the correct grease, and tighten the axle nut to the vehicle’s specification. Check for play again after the first few trips.
- Replace bearings on both sides when worn
- Inspect the hub and spindle surfaces
- Check the hub seal during the job
- Re-check play after the first drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16536.05 |
| UPC | 804314153724 |
| Position | Rear |
| Axle | Dana 44 |
| Quantity | One required per axle |
| Warranty | Limited five-year warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1970-1975 Jeep CJ5, the 1986 CJ7, the 1993-1998 Grand Cherokee (ZJ), the 2004-2006 Wrangler (LJ) Unlimited and Unlimited Rubicon, the 1997-2006 Wrangler (TJ), and the 2007-2011 Wrangler (JK).
The JK entries stop at 2011, and the TJ entries cover 1997-2001 and 2003-2006 with no 2002 entry. Confirm your vehicle’s year, model and trim before ordering.
What’s included
This part is one rear axle wheel bearing.









