Overview
The Crown Automotive J8124051 is the inner pinion bearing kit for the Dana 44 axle. The inner pinion bearing sits closest to the ring gear and supports the pinion gear on that side.
It fits the 1987-1990 Cherokee (XJ), the 1986 CJ7, the 1986-1992 Comanche, the 1984-1991 Grand Wagoneer (SJ), the 1974-1988 J10, the 1974-1986 J20, the 1974-1990 Wagoneer (SJ), the 1997-2002 Wrangler (TJ) and the 1988-1995 Wrangler (YJ).
Key features
- Inner position for the Dana 44 pinion
- Direct fit, Crown Automotive part number J8124051
- Covers several Jeep trucks and Cherokee models
- Wrangler YJ and TJ coverage
Before you buy
The inner pinion bearing sits on the ring gear side of the carrier and carries the load of the pinion gear as the axle turns under power and under braking. Because the pinion and ring gear are set as a matched pair, a worn inner bearing can let the pinion shift, which often shows up as a whine that changes with throttle or as play felt through the drivetrain. Before buying, confirm the old bearing is the inner unit and inspect the ring gear and pinion, since a new bearing will not correct gear damage.
Bearings in this position are usually replaced together with the crush sleeve or collapsible spacer and the pinion seal, because those parts are disturbed when the pinion comes out. Check the shim pack and the carrier bore for scoring at the same time. Keeping the new bearing clean and free of grit during installation helps it last on an axle that sees rough trail use.
- Confirm the bearing is the inner unit before pulling the pinion
- Inspect the ring gear and pinion for wear or chipped teeth
- Replace the crush sleeve and pinion seal during the same job
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8124051 |
| UPC | 848399079500 |
| Position | Inner |
| Axle | Dana 44 |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1987-1990 Jeep Cherokee (XJ), the 1986 CJ7, the 1986-1992 Comanche, the 1984-1991 Grand Wagoneer (SJ), the 1974-1988 J10, the 1974-1986 J20, the 1974-1990 Wagoneer (SJ), the 1997-2002 Wrangler (TJ) and the 1988-1995 Wrangler (YJ).
Confirm fit for your vehicle’s year, model and trim before ordering, especially for Wrangler (JK) and Wrangler (LJ) models.
Installation notes
Pinion bearing preload is set when the pinion is reassembled, so a professional setup is recommended for this kit.
What’s included
This part is an inner pinion bearing kit.
Not included: the pinion gear and ring gear, which are separate parts.









