Overview
The Omix-ADA 16513.83 is an AMC Model 20 (AMC 20) rear ring and pinion set with a 3.73 ratio for the Jeep CJ5, CJ7 and Scrambler. The manufacturer text summarizes the application as “76-86 CJ” and the manufacturer list covers the CJ5 from 1976-1983, the CJ7 from 1976-1986 and the Scrambler from 1981-1985.
Re-gearing to 3.73 restores performance after taller tires are fitted. The ratio is built from 41 ring teeth and 11 pinion teeth, and the set comes with the pinion bearings and other hardware needed for the pinion side.
Key features
- AMC 20 rear ring and pinion set
- 3.73 gear ratio, 41X11 teeth
- Includes pinion bearings, cups, pinion nut, washer, oil seal, slinger, ring bolts and shim kit
- Fits CJ5, CJ7 and Scrambler models
- Listed by Omix-ADA as a direct fit
Setting up a re-gear
Changing to a 3.73 ratio is a deeper job than a bolt-on upgrade. The ring gear and pinion must be matched as a pair, and the pinion depth and backlash both have to be set before the gears are run. Tooth contact is checked with marking compound to confirm the pattern sits correctly on both the drive and coast sides, and the result should be checked before the axle goes back in service.
Gear sets are usually installed along with the carrier bearings, pinion seal and axle fluid, since these are opened together. Fresh gear oil with the correct additive for limited-slip units, if fitted, is a typical step. A break-in period after the rebuild lets the new teeth seat, so drive gently for the first short stretch and check for leaks and noise afterward.
- Check backlash and tooth contact before assembly
- Replace worn carrier bearings during the rebuild
- Confirm the tire size change before choosing a ratio
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16513.83 |
| UPC | 804314047108 |
| Axle | AMC 20 |
| Axle position | Rear |
| Gear ratio | 3.73 |
| Tooth count | 41X11 |
| Fit type | Direct Fit (per Omix-ADA) |
Not stated by the manufacturer: the material, the carrier bearings, and the part’s own weight.
Vehicle fitment
It is a rear axle set that fits 1976-1983 CJ5, 1976-1986 CJ7 and 1981-1985 Scrambler models. Confirm your rear axle is an AMC 20 before ordering.
The manufacturer fitment list for part 16513.83 covers: 1976–1983 Jeep CJ5; 1976–1986 Jeep CJ7; 1981–1985 Jeep Scrambler.
Not listed: CJ5 before 1976 and after 1983, CJ7 outside 1976-1986, the Wrangler (YJ, TJ and later) and any Dana-axle vehicle. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The included shim kit points to a pinion depth setup, so the work involves measuring and adjusting depth and backlash and checking the tooth contact pattern. A shop with the right tools and a break-in period afterward are typical for a new gear set.
What’s included
- Ring and pinion set, 3.73 ratio (41X11 teeth)
- Pinion bearings and cups
- Pinion nut and washer
- Oil seal and slinger
- Ring bolts
- Shim kit
Not included: Carrier bearings and axle fluid are not included.








