Overview
The G2 2-2034-488RX is a 4.88 ratio thick front reverse ring and pinion for the Dana 60 front axle. It works with carriers rated at 4.10 and down, so the carrier ratio must be at or below 4.10 for this set.
G2 says its gear sets are built for oversized tires and high performance engines. This thick reverse version is made from computer heat treated 8620 steel with double shot peened and double lapped surfaces.
Key features
- Thick front reverse 4.88 ring and pinion
- Dana 60 front axle
- For use with 4.10 and down carriers
- Computer heat treated 8620 steel
- Double shot peened surfaces
- Double lapped gear set
- Manufactured to O.E. specifications
- 10 year warranty from G2
Thick reverse gears explained
A thick reverse ring and pinion uses a heavier gear body and a reverse mounting layout, which suits front axles that see high steering and drive loads. On a Dana 60, the thicker tooth profile helps the gears handle torque from big tires, though it still needs careful setup.
Because carrier and pinion depth are critical, a shop with a dial indicator and the right setup tools is worth finding. Check the pinion bearings, crush sleeve and carrier for wear during the job, and inspect the front axle shafts and seals. Quiet running after break-in is a good sign that the mesh is correct.
- Confirm the carrier is 4.10 or lower in ratio
- Inspect front axle seals during the swap
- Expect a break-in period before heavy towing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2034-488RX |
| UPC | 631410094206 |
| Gear ratio | 4.88 |
| Axle location | Front |
| Axle type | Dana 60 |
| Popular axle manufacturer | Dana |
| Carrier requirement | 4.10 and down |
| Version | Thick, front reverse |
| Material | Computer heat treated 8620 steel |
Vehicle fitment
It is a 4.88 set for the Dana 60 front axle. Confirm the axle and carrier before ordering.
It covers the front Dana 60 position only, not rear gears or other Dana sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Thick reverse gears need pinion depth, backlash and bearing preload set by a driveline shop, followed by a break-in period on the 4.88 ratio.
What’s included
A matched thick front reverse ring and pinion for the Dana 60 front axle.
















