Overview
The G2 Axle and Gear 4-JKRUB-538 is a 5.38 ratio front and rear ring and pinion kit for the Rubicon Jeep Wrangler JK. The title’s JK code places it in the 2007-2018 Wrangler range. The kit is set up for Dana 44 gears at the front and the rear, so one order covers both ends of the driveline.
The gears are designed to hold up to oversized tires and high performance engines, for both the front and rear axle locations.
Key features
- Front and rear 5.38 ratio ring and pinion sets
- Dana 44 gears at both the front and rear axle locations
- Installation kits for both axles included in the gear swap
- Designed for oversized tires and high performance engines
- Universal fit, so confirm both axle types before ordering.
Gear ratio and tire size
Gear ratio and tire diameter work together. A taller tire lowers the effective ratio, while a lower ratio with large tires can make the engine work harder on the highway. Choosing the right ratio means looking at the tire size you plan to run, not only the gear set.
Heavier tires and a larger engine load the front and rear gears differently, so the axles should be checked after the first drives. Look for heat at the carrier, noise under load and any change in the tooth pattern.
A ratio change also affects how the truck pulls, brakes and shifts. Plan the drivetrain as a set, since the transfer case, driveshafts and tires all play a part in how the new gears feel on the road.
- Set backlash on both axles after installation
- Recheck carrier bolts after the first trail runs
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-JKRUB-538 (G/24-JKRUB-538) |
| Gear ratio | 5.38 |
| Axle location | Front and rear |
| Axle manufacturer | Dana |
| Axle type | Dana 44 JK |
| Models | Rubicon |
Vehicle fitment
Fitment is taken from the product name, which gives the JK chassis code for the Jeep Wrangler (JK), 2007-2018. The kit is set up for Dana 44 axles at the front and rear of the Rubicon JK.
The 2007-2018 range covers the JK generation only, so TJ, LJ, YJ and JL Wranglers are not covered by this kit. The catalog also shows the kit as universal fit, so confirm the front and rear axle types with the manufacturer before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set pinion depth and gear backlash on both axles after the new sets are installed, and check the tire size against the 5.38 ratio before the swap. The front and rear master installation kits are matched to their own gear sets, so keep them separate.
What’s included
Front and rear 5.38 ring and pinion sets, with matched master installation kits for both axles.
Not included: Carriers are not part of this kit.
















