Overview
The G2 Axle and Gear 1-2096-373 is a 3.73 ratio O.E.M. series ring and pinion built for the GM 9.25 inch IFS front axle. It is sold for the front location and suits the 9.25 inch IFS axle type.
Designed to run cooler and quieter than aftermarket gears, the O.E.M. series is produced under contract with original equipment manufacturers. The 3.73 ratio gives more torque multiplication at the wheels than a 3.42 set.
Key features
- O.E.M. series 3.73 ring and pinion
- GM 9.25 inch IFS front axle type
- Front axle location
- Built under contract with original equipment manufacturers.
- Runs cooler and quieter than aftermarket gears.
Break-in and setup steps
A new ring and pinion needs correct setup before it is loaded. Pinion depth sets the tooth contact, backlash controls how the teeth mesh, and bearing preload keeps the pinion steady. Changing any one of these affects noise and wear, so the three should be set together.
Break-in matters because the first stretch of driving beds the teeth together. Use light throttle and avoid towing or hard launches during this period, and change the gear oil once the break-in is finished to remove fine debris. Keep the setup sheet with the vehicle records so a future technician can see the measured values. That saves time at the next service and makes noise diagnosis easier.
- Use gear oil suited to the axle
- Check the axle vent for clear airflow
- Listen for whine during the first drives
- Re-torque cover bolts after initial use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 1-2096-373 |
| UPC | 631410093117 |
| Gear ratio | 3.73 |
| Axle location | Front |
| Axle type | GM 9.25 inch IFS |
| Popular axle manufacturer | GM |
| Series | O.E.M. |
Vehicle fitment
This 3.73 set is not tied to a particular vehicle model or year. It is built for the GM 9.25 inch IFS axle at a 3.73 ratio, so confirm the axle type before ordering.
Only the GM 9.25 inch IFS is named for this 3.73 set. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth, backlash and bearing preload on the IFS 3.73 gears should be set by a driveline shop, then the front axle should be run through a break-in period.
What’s included
A matched O.E.M. series ring and pinion for the 9.25 inch IFS front axle.















