Overview
The Icon Suspension 58450 is a tubular uniball upper control arm kit designed for 2005 and newer Toyota Tacoma 2WD and 4WD trucks. The arms are built from 1026 DOM seamless tubing with CNC bent sections, and they use PTFE lined uniball bearings with a 17-4 stainless adapter pin.
Weak factory ball joints can limit suspension travel, especially with performance coil-over shocks. The uniball and adapter combination increases upper arm misalignment range, which allows smoother wheel travel without factory ball joint bind.
Key features
- 1026 DOM seamless tubing, CNC bent
- CNC machined bushing housings and sleeves
- CNC machined uniball cup
- 1-inch stainless PTFE lined uniball bearings
- 17-4 high grade stainless steel uniball adapter pin
- Precision CNC machined pin for a close, factory-style fit
Setting up the arms
Upper control arms hold the top of the axle in place and set camber and caster, so changing them affects how the truck tracks and steers. A uniball joint gives the arm more range of motion than a factory ball joint, which helps on trucks with larger suspension travel. The trade-off is that the new geometry needs to be measured and adjusted to suit the vehicle.
Plan the install around a full alignment afterward. Check the arm bores, bearings and adapter for wear before assembly, and grease the bearings if the design calls for it. Recheck the bolts and jam nuts after the first few trail runs, since they can loosen as the joints seat.
- Check caster and camber after installation
- Inspect uniball bearings and adapter before assembly
- Recheck bolts and jam nuts after the first drives
Specifications
| Brand | Icon Suspension |
|---|---|
| UPC | 70000596770 |
| Tubing | 1026 DOM seamless steel, CNC bent |
| Bushing housings and sleeves | CNC machined |
| Uniball bearings | 1-inch stainless, PTFE lined |
| Adapter pin | 17-4 high grade stainless steel |
| Position | Front upper |
| Fitment type (per copy) | Direct fit |
Vehicle fitment
The kit is designed for 2005 and newer Toyota Tacoma 2WD and 4WD trucks. Confirm fit for your vehicle’s year, model and configuration before ordering.
This kit is designed only for the Tacoma trucks named above.
Installation notes
Upper control arms change alignment, and the uniball design increases misalignment range, so have caster and alignment checked after installation. Support the truck on rated jack stands whenever you work under it.
What’s included
The kit is the tubular upper control arm assembly with uniball bearings and adapter pin. Check the hardware against your installation before starting.
Not included: Coil-over shocks are not part of the kit. The 2.5 VS Series coil-over shocks are the suggested pairing for these arms.
