Overview
The G2 Axle and Gear CORE 44 rear axle assembly, part number C4YSR373EC0, pairs a Dana 44 housing with a 3.73 ratio and an Eaton E-Locker. It fits 1987-1995 Jeep YJ Wranglers and 1984-2001 Jeep XJ Cherokees.
G2 presents the housing as a new rear axle design built to carry loads that would bend a stock Dana 30 or a Rubicon Dana 44. Stock Dana 44 ring and pinions, axle shafts and all aftermarket lockers are said to fit, which allows familiar parts to be reused.
Key features
- CORE 44 rear housing design from G2
- Accepts stock Dana 44 ring and pinions and axle shafts
- Accepts all aftermarket lockers
- 3.73 gear ratio
- Eaton E-Locker
- Direct fit listing
Upgrading an older Jeep axle
Older Jeep Wranglers and Cherokees often have worn axles, bushings and driveline parts that show up once a stronger housing is installed. Because this assembly replaces the full rear axle, the mounting points, brake lines, shocks and track bar connections should be checked before the vehicle goes back on the road. A shop can confirm alignment and clearance.
An E-Locker changes how the axle behaves on pavement, so it is worth driving gently until the vehicle has been used with the locker engaged a few times. Driveline angle also matters on lifted or modified Jeeps; a shaft running at the wrong angle can vibrate at speed and wear U-joints early. Checking the driveshaft yoke and U-joints is a good habit after any axle swap.
- Inspect U-joints and driveshaft alignment
- Check brake lines routed to the new housing
- Confirm shock and track bar mounts after install
- Drive gently until the locker feel is familiar
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4YSR373EC0 |
| UPC | 631410134346 |
| Housing type | CORE 44 rear axle housing |
| Front or rear | Rear |
| Gear ratio | 3.73 |
| Locker | Eaton E-Locker |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1987-1995 Jeep YJ Wranglers and 1984-2001 Jeep XJ Cherokees. Those years and models are the only coverage for this assembly.
Grand Cherokee, TJ, JK and JL models are outside the years and models stated here. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because this is a complete rear axle assembly, fitting it means replacing the existing rear axle as a unit. Gear mesh and bearing preload need to be set by a shop with ring and pinion experience, and incorrect mesh can destroy a gear set quickly, so confirm the setup before driving.
What’s included
The assembly is a complete rear axle with an Eaton E-Locker and 3.73 ratio.
Not included: Grand Cherokee, TJ, JK and JL models fall outside this coverage. Compare your vehicle’s year, model and trim with that range before purchase.





